Owner manual

ManualsBrandsBanner ManualsSpecial machineryEZ-ARRAY Lens Shields

EZSS Series Snap-On Lens Shields

For use with EZ-SCREEN

Type 4 Emitters and Receivers

Printed in USA 02/12 P/N 127944 rev. B

Features

• Provides impact protection for EZ-SCREEN 14 mm and 30 mm resolution emitters

and receivers

• C

lear PETG co-polyester lens shields snap into place; need no foam gasket for

attachment

• Can be removed and reinstalled easily

• F

oam gasket (neoprene sponge) included to prevent debris from falling between lens

shield and sensor window

• Reduces sensing range by approximately 10% per shield (20% per pair)

Models

Lens Shield

Model

Fits Emitter/Receiver

Models

Lens Shield Overall

Length

EZSS-150 SLS..-150.. 236 mm

EZSS-300 SLS..-300.. 346 mm

EZSS-450 SLS..-550.. 496 mm

EZSS-600 SLS..-600.. 645 mm

EZSS-750 SLS..-750.. 795 mm

EZSS-900 SLS..-900.. 945 mm

EZSS-1050 SLS..-1050.. 1094 mm

EZSS-1200 SLS..-1200.. 1244 mm

EZSS-1350 SLS..-1350.. 1394 mm

EZSS-1500 SLS..-1500.. 1543 mm

EZSS-1650 SLS..-1650.. 1693 mm

EZSS-1800 SLS..-1800.. 1843 mm

37.0 mm

(1.46")

1.6 mm

(0.06")

20 mm

(0.79")

Figure 1. Lens shield dimensions – cross-section

Summary of content (4 pages)

PAGE 1
® EZSS Series Snap-On Lens Shields For use with EZ-SCREEN® Type 4 Emitters and Receivers Features • Provides impact protection for EZ-SCREEN 14 mm and 30 mm resolution emitters and receivers • Clear PETG co-polyester lens shields snap into place; need no foam gasket for attachment • Can be removed and reinstalled easily • Foam gasket (neoprene sponge) included to prevent debris from falling between lens shield and sensor window • Reduces sensing range by approximately 10% per shield (20% per pair) Mod
PAGE 2
EZSS Series Snap-On Lens Shields Installation The EZSS series lens shield can be installed either by sliding it over the emitter/receiver housing or by snapping it into place. Sliding it on must be done prior to installing the sensors; snapping it into place can be done after sensor installation. If side brackets are used, notches must be cut into the sides of the shield, before snapping it into place. Each shield is 2 mm longer than the sensor housing section; it will overlap the blind end-cap by 2 mm.
PAGE 3
EZSS Series Snap-On Lens Shields Adjacent Reflective Surfaces WARNING . . . Avoid Installation Near Reflective Surfaces Avoid locating the defined area near a reflective surface; it could reflect sensing beam(s) around an object or person within the defined area, and prevent its detection by the EZ-SCREEN System. Perform the trip test, as described in Section 3.4.4 of the EZ-SCREEN Instruction Manual, to detect such reflection(s) and the resultant optical short circuit.
PAGE 4
Banner Engineering Corp Limited Warranty Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture which, at the time it is returned to the factory, is found to have been defective during the warranty period.