Bambi Lab—1~ meter Buick Start Please review the entire guide before operating the printer. = Safety Notice: Do not connect to power until assembly Is complete.
Component Introduction Teo! Head 8D Card Screen USE Charging Port FEET Tube Anchor Belt Pensioner Bambi Bus Port 4-Pin Build Plate Excess Chute Power Socket
Accessory Specification Er Filament Spare Hot End Nozzle Wiping Pad (x2) Screen Power Cord Unclogging Pin Tool FEET Tube Bambi Scraper Allen Key H1.
Tool Head Unlock Cut the zip tie securing the tool head. Remove the cardboard from the tool head, Remove the foam from the excess chute.
Spool Holder & FEET Tube Anchor Assembly “We recommend using the short end of the Allen Kay to unlock the straws more serially Remove the screws as pictured with an Allen Secure the spool holder with two screws from Key H2. the accessory box. Secure the FEET tube anchor with two screws Place the FEET tube as pictured. Make sure from the accessory box, Beth ends of the FEET tube are Inserted tightly.
Hot Bed Unlock & Screen Installation Remove the three screws with an Allen Key OTOH Insert the LCD cable into the port by plugging it unlock the hot bed. into the terminal as pictured. Attention: Bend the LCD cable towards the Inset the screen back to the slot on the printer, opening on the back of the screen as pictured.
Printer Binding 1. Download the Bambi Handy App. Register and log in to your Bambi Lab account. 2. Connect the printer to power. Follow the instructions on Scan the code to rr the screen until getting to the page shown on the right side. Cos Hod Cello sled on 3. Use Bambi Handy to scan the (R code on the screen, and bind your printer with your Bambi Lab account. pare + | Lane Follow the instructions on the screen to complete the initial calibration.
First Print Insert filament into the FEET Tube. Keep pushing Select 3", and heat the nozzle to the the filament until it can not move forward. recommended temperature for the filament. *Wa recommend using the supplied Bambi PLA Basic for your Select "gg #" several times until the first tots print. filament comes out from the nozzle and cannot be pulled out from the FEET tube anchor manually. o Select "Bi" and select a file to start the first print.
Bambi Studio o a i During printing, you can remotely monitor your print, or pause/stop printing on the "Device" interface. "The Hive view can be seen only If a caners bs mounted.
Specification from Specification Printing Technology Fused Deposition Modding Bulls Volumetric) 258%266%256 mm Body Chassis Steel Shell Printable Hot End All-Metal Truculent Gears Ste! Nozzle Stainless Steel Max Hot End Temperature 300°C Tool Head Nozzle Diameter (included) 04mm Nozzle Diameter {Optional} 0.
Customer Support Please visit the Bambi Lab Wiki for more setup and maintenance tutorials.
ose seam ose Sod Bios TRS BG) TT pal RS Ler And rE Sen sot | TUNING ARG PUE DIRIGIBLE Cannes J | HERB hE RT Bugs, pu Seuss BEB tog HE bem em meme ene WHEY eg rn cc Sort AOS mon od coe
