Manualshelf

Assembly Instructions

ManualsBrandsBackyard Creations ManualsOutdoor DecorOutdoor Pedestal Clock / Analog Thermometer
1
Parts Included:
Assembly Time:
Usage:
When using this weather station outside, place unit in shaded area away from direct sunlight for
most accurate reading of gauges, as direct sunlight may cause some deviation in gauge readings.
Note: Temperature gauge accuracy is +/- 2 degrees Celsius or +/-3 degrees Fahrenheit.
Humidity gauge accuracy is +/- 5%.
Note: Outside clocks must be brought inside when outside temperature drops below 20 degrees (F).
Adjustment:
1) Base can be installed with adjustable screw-in foot tabs to stand on hard surfaces, stakes for
insertion into grass/soil surfaces, lag bolts for cement surfaces or wood screws for deck
installation. Thread foot tabs or stakes into the four holes under base. If foot tabs are used,
adjust height as necessary levelling fixture for uneven surfaces. If stakes are used, find level,
firm grass/soil area for inserting stakes. If lag screws are used, insert lag screw and secure
top portion onto base using lock washer, washer and hex nut. If wood screws are used, screw
firmly onto level wood surface. (Diagram 1)
2) Slide base cover down to fit over base. (Diagram 1)
3) Attach decorative bottom to base. Next, attach bottom pole to base. (Diagram 2)
4) Slide decorative coupler onto bottom pole and slowly slide down to top of Decorative Bottom.
(Do not yet secure). (Diagram 2)
5) Thread top pole to bottom pole. (Diagram 2)
6) Slide decorative coupler back up to centre of entire pole, so it covers the seam between top
and bottom poles. Using Allen key provided, tighten threaded nipple embedded
inside coupler until coupler is tight and secure. (Diagram 2)
7) Slide Decorative Arm (for display head) down onto Top Pole. Next place Decorative Arm
(for plant hanger) onto top pole as shown and secure with the two allen screws and
Allen Key provided. (Diagram 2)
8) Slide the peg on top of the head up into the hole in the bottom of Decorative Arm (for display
head) and secure with screw provided. (Diagram 3)
9) Slide the Decorative Ball down onto the Top Pole and tighten with Allen Key. (Diagram 4)
Assembly:
Time: 20-30 minutes
Cement Installation
Wood Deck Installation
E1 E2
Stake
Bottom Pole
Coupler
Allen
Key
Allen
Screw
Top Pole
Base Washer
ScrewDisplay Head
Washer Lock Washer Lag BoltHex Nut
Wood
Screw
Base
Cover
Decorative
Ball
Decorative Arm
(Plant hanger)
Decorative Arm
(Display Head)
Diagram 2Diagram 1 Diagram 3 Diagram 4
MADE IN CHINA
M
A
D
E
I
N
C
H
I
N
A
Temperature
Temperature
Baro
Humidity
A
N
I
H
C
N
I
E
D
A
M

Summary of content (1 pages)