Specifications

30
3-3. Spin-drying Cycle
1) Drainage
$ Drainage set time is 1min.
% When drainage is completed, 1 minute is reduced from the overall cycle.
2) Balance Spin-drying
$ Spreading the laundry : Rotating the same 45rpm with left and right direction altematively.
% Attaching stop : Attaching the laundry to drum inside with constant speed.
& Unbalance checking point : First step, check the U.B at 95 rpm, 160rpm
Second step,check the U.B at 95 rpm, 350rpm
Third step, at 300rpm. if the unbalance data is over the criterion
This process will be rpeated
' Drain step : Drain at water around 160rpm
, After drain, check the unbalance data again. This is so-called balance spin step.
3) R (Real) Spin-drying
$ 'R spin-drying' refers to the process until completion of spin-drying after B spin-drying.
% The r.p.m reached differs according to the spin-drying cycle selected.
& When acceleration ends during spin-drying, constant-speed operation is carried out at the r.p.m set in
the selected cycle. Breaking is carried out after deceleration to app. 450 r.p.m.
' When stopping cycle by pressing temporary stop button during spin-drying, breaking is carried out to
stop motor.
, Max. r.p.m operation time according to spin-drying selection
4) No Drainage
$ Cycle is completed without drainage after rinsing is finished
Spin-Drying Classification Max. r.p.m Time of Max. r.p.m Maintenance Remarks
Low 550 r.p.m 330sec
Medium 790 r.p.m 270sec
High 990 r.p.m 40sec
Extra High 1050 r.p.m 10sec