Instructions / Assembly

Step 14
SR27hw
● Parts Needed For ●
Right Roof Panel
●●
●●
● 9086 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Install the first roof
panel at the back right corner of the
building. Each screw and bolt in the
roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square
and level. This will make the roof
panels fit better, and holes will
align. Don't anchor the floor frame.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1 Locate the roof panels and find the
right roof panel part number 9086.
2 Position the right roof panel at the
back right corner and fasten to the
gable with six bolts and nuts and roof
beams using eight screws. Do not
fasten the lower end of the panel to
the side wall angle at this time.
27
Bolt
(6)
STEP
2
Nut
Washer
Gable
9086 Right Roof Panel
1
2
3
4
5
(4) Screws
STEP
1
1
3
5
7
2
4
6
8
9086
90869087
9087
7743
7743
7743
7743
10
9
7743
7743
6
Hint: Follow the fastener sequence
shown for proper alignment.
(8) (6)