ITEM #0970869 LED LIGHTED MIRROR MODEL #MIR3032 Français p. 9 Español p. 17 ATTACH YOUR RECEIPT HERE E465631 Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-527-1292, 8:30 a.m. - 5 p.m.
PACKAGE CONTENTS PART DESCRIPTION QUANTITY A Fixture 1 B Mounting Plate 1 C Adhesive (preassembled to sheet (D)) Sheet (preassembled to fixture (A)) Plastic Washer (preassembled to mounting plate (B)) 4 D E B A C E 1 D 1 HARDWARE CONTENTS (shown actual size) AA Wire Connector Qty. 3 BB CC DD Machine Screw Fixture Screw Qty. 2 Qty. 4 Plastic Anchor Qty. 4 SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS.
SAFETY INFORMATION • DO NOT connect the bare or green insulation fixture ground wire to the black (HOT) current-carrying wire or the white (NEUTRAL) house wire. Connection of the bare or green fixture ground wire to the black or white house wires may cause metal parts of the fixture to carry electrical currents. Under this condition anyone coming in contact with the fixture will receive electrical shock, which could cause serious injury or death.
SAFETY INFORMATION CAUTION • All fixtures must be mounted to an outlet box that is supported by the building structure. • Do NOT tamper with or attempt to repair LED component of fixture. The light source is designed for this specific application and should not be serviced by untrained personnel. If any servicing is required, call our customer service department. • Total wattage for this fixture is 24 watts; do not attempt to replace the LEDs.
ASSEMBLY INSTRUCTIONS 3. Remove sheet (D) from fixture (A). Determine the approximate location for the fixture (A). Place sheet (D) against the wall using the adhesive (C), and mark the location of the holes using a pencil or a marker (not included). 3 C D 4. Then, using a 1/8 in. drill bit (not included), drill four pilot holes at the marked locations. 4 D 5. Position plastic anchor (DD) in each pilot hole. Gently tap plastic anchors (DD) with a hammer (not included) until flush with wall surface.
ASSEMBLY INSTRUCTIONS 6. Thread wires through mounting plate (B) and plastic washer (E). Prepare wires by stripping 3/4 in. of insulation from wire ends using wire strippers (not included). Connect WHITE wire from fixture (A) to WHITE wire from outlet box using existing wire connector or wire connector (AA). Connect BLACK wire from fixture (A) to BLACK wire from outlet box using existing wire connector or wire connector (AA).
ASSEMBLY INSTRUCTIONS 8. Attach mounting plate (B) to outlet box (not included) using existing washers and outlet box screws or the machine screws (BB). NOTE: If the outlet box screws required for your outlet box are of a different size than the machine screws (BB), consult a licensed electrician before proceeding. Tighten machine screws (BB) to secure mounting plate (B). Push plastic washer (E) into mounting plate (B). 8 B BB E CAUTION: Make sure the outlet box can support 35 lbs. hanging weight.
OPERATING INSTRUCTIONS Tapping the touch sensor on fixture (A) turns light ON and OFF. Touch Sensor A CARE AND MAINTENANCE • Wipe fixture with soft, damp cloth. Do not use an abrasive cleaner on fixture. . TROUBLESHOOTING WARNING: Before beginning work, shut off the power supply to avoid electrical shock. PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Light does not come on initially or no longer comes on. 1. Power is OFF. 2. Faulty connection. 3. LED component is not working properly. 1.
