Instruction Manual

State Series LED Outdoor Wall Sconce
Models: SEW5121500L30MVxx, SEW5182300L30MVxx
Page 1 of 1 8061013 R0
Safety Precautions
Read all safety precautions and installation instructions carefully
before installing or servicing this fixture. Failure to comply with
these instructions could result in potentially fatal electric shock
and/or property damage.
It is recommended that a qualified electrician perform all wiring. This
fixture must be wired in accordance with all national and local
electrical codes.
Do not handle any energized fixture or attempt to energize any
fixture with wet hands or while standing on a wet or damp surface or
in water.
This fixture is designed for use in a 120-277VAC, 60Hz fused circuit.
Make sure that the power source conforms to the requirements of the
fixture (see labels on fixture housing).
To reduce the risk of electrical shock, and to assure proper operation,
this fixture must be adequately grounded. To accomplish proper
grounding, there must be a separate ground wire (green) or bare metal
contact (metal conduit) between this fixture and the ground
connection of your main power supply panel. The green ground
screw location is clearly marked on the gem bar.
This fixture is intended to be used for general outdoor lighting in wet
locations, mounted at least 48 inches above ground level.
Assembly Instructions
1. Preparing for installation
A. Disconnect electrical power before installing or servicing any
part of this fixture.
B. Remove all parts and parts bags from carton.
C. Separate fixture back plate (5), mounting bracket (2) and fixture
front cover (7).
2. Wiring. All wiring must take place inside junction box.
Caution: Make sure power is off at fuse or circuit breaker box. Check
power wires for damage or scrapes. If power supply wires are within three
inches of driver use wire suitable for at least 90°C (194°F). Note: Most
dwellings built before 1985 have supply wire rated to 60°C. Consult a
qualified electrician before installing.
A. This unit will not operate properly unless connected to a
“grounded” electrical circuit. Electrical shock, overheating, low
or no light output, and shortened lamp life can result if proper
grounding is not done. Securely attach power source ground wire
and fixture copper ground wire to green ground screw on mounting bracket.
B. Using wire nuts (provided), connect white (common) supply wire to white fixture lead. Connect black (hot) supply wire to
black fixture lead. Do not mix wires. Pull on each wire lead to make sure connections are secure. Make certain no bare wires
are exposed outside of wire connectors.
3. Fixture mounting.
Thread crossbar screws (3) into threaded holes in crossbar (2). Check that spacing between screws matches holes in back plate
(5). Attach crossbar (2) to outlet box (1) (not provided) with outlet box screws (4) provided with your outlet box using the slots in
the crossbar.
Place fixture back plate (5) over outlet box (1) allowing crossbar screws (3) to pass through holes in back plate. Secure with cap
nuts (6).
Secure fixture front cover (7) onto back plate (5) with mounting screws (8), see note #4A below.
4. For Wet Location Use:
A. Place small amount of silicone or water proof caulk (not included) at the mounting holes.
B. Place a small bead of silicone or water proof caulk (not included) around the fixture (7) where it contacts with the surface of
wall, apply on top and two sides, but not on bottom.
5. Restore power at fuse or circuit breaker box.
Limited Factory Warranty
AFX Inc. hereby warranty that this fixture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 5 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of
defective fixture or components; it does not cover failure due to improper installation, misuse, mishandling, or damage incurred in transit.