User`s guide

10 Hardware Installation and User’s Guide

Hardware Installation

This chapter provides information on installing the ICP RAID controller, programming

the Flash memory, setting jumpers, and using the LEDs and alarms to diagnose the

controller.

2.1 Installation Procedures

Warning:

Shock hazards may be present inside the computer in which this controller is being

installed. Disconnect all power cords to the computer before the removal of any

covers.

Follow the warnings noted in your computer’s user manual before installing this board.

ONLY after reinstallation of all the covers should you reconnect the power cords and

power-up the computer.

Note:

Take precautions to prevent electrostatic discharge (ESD) damage before handling the

ICP RAID Controller.

2.1.1 Computer System Hardware Requirements

• Computer with CD-ROM drive

• One available 64-bit/66MHz PCI slot for optimal performance; however, the controller

is backwards compatible with all 33MHz PCI expansion slots.

• PCI 2.2 compliant system BIOS