900MHz WIRELESS INDOOR/OUTDOOR SPEAKER Installation and Operation Manual Model AW811
Table of Contents I. II. III. IV. V. VI. VII. VIII. IX. X. Location of functions………..…………………………………………….… 2 Connecting the speaker system............................................................ 3 Adjusting the transmitter...................................................................... 5 Tuning the speaker…………………………………………………………… 6 Turning the speaker off……………………………………………………… 7 Recharging the batteries……………………………………………………. 7 More helpful information ..................................................
I. Location of Functions Speaker Side View: Speaker Front View: A D B C A. Power/tuning indicator light B. Power/tuning/volume control C. Speaker power input jack D. Left/mono/right switch Speaker Top View: Speaker Bottom View: E G F E. Carrying handle F. Non-skid table surface G. Battery compartment cover Transmitter Front View: Transmitter Back View: J H H. Power indicator light K I I. Transmitter power input jack J. Audio input cable K.
Audio Output II. Connecting the Speaker System Audio Output I. Powering the Transmitter Connect the small, round plug from the transmitter AC power adapter (L) to the transmitter power input jack (I) and plug the other end of the transmitter Sortie audio AC power adapter (L) into any standard 120V AC wall outlet. Audio Output Note: Be sure to use the AC power Transmitter AC Power Adapter (L) I 120V AC wall outlet adapter rated 12V DC 100 mA. Sortie audio Note: There is no transmitter ON/OFF switch.
Warning: This product is designed to work with line level outputs or headphone outputs only. DO NOT connect it directly to speaker outputs as it will permanently damage the transmitter. Sortie audio III. Powering the Speaker There are two options to power your wireless speaker: i. AC Power Adapter: Speaker AC Power adapter (M) 120 V AC Wall Outlet Speaker power input jack (C) 1.
III. Adjusting the Transmitter J I K H H. Power indicator light I. Transmitter power input jack J. Audio input cable K. Channel select switch 1. Turn ON your audio source (i.e., A/V receiver, TV, stereo, etc.) and play music at a normal listening volume. 2. Set the channel select switch (K) on the back of the transmitter to 1, 2 or 3. The transmitter provides three different broadcasting frequencies.
IV. Tuning the Speaker Speaker Front View: Speaker Side View: D A A. Power/tuning indicator light B C B. Power/tuning/volume control C. Speaker power input jack D. Left/mono/right switch 1. Press the Power/tuning/volume (B) up to turn the speaker ON. The power/tuning indicator light (A) will illuminate red until the speaker is tuned to the transmitter and then the light will illuminate green, indicating that the speaker is tuned properly. You should hear sound coming from the speaker now.
V. Turning the Speaker Off 1. Press and hold the Power/tuning/volume (B) up to turn the speaker OFF. You will need to hold the control for about 1.5 seconds for the speaker to turn off. 2. Confirm that the speaker is off by verifying that the power/tuning indicator light (A) is no longer illuminated. VI. Recharging the Batteries The speaker will automatically charge the rechargeable batteries (NiMH or NiCd) only when the batteries are installed and the speaker is plugged in with the AC power adapter.
Hint: If your VCR (or other audio source with RCA jacks) only has a single audio output, you will need another RCA “Y” cable. It differs from the “Y” Cable Adapter included with this speaker. It will have a single male RCA plug and 2 female RCA jacks. Connect the dual RCA plugs from the included “Y” cable adapter to the 2 female RCA jacks on the second “Y” cable, and then connect the single male RCA plug of the second “Y” cable to the single audio output of the VCR. ii.
VIII. Troubleshooting The following troubleshooting guide takes you through some of the more common problems associated with the installation and/or operation of a wireless system. If the problem persists, please call 1-800-732-6866 and a knowledgeable customer service representative will assist you.
IX. Specifications & Features Transmitter: Omnidirectional Effective transmitting range: up to 300 feet* 3 selectable broadcast frequencies (between 912.5 and 914.5 MHz) Stereo audio input with 3.
X. Warranty 12 MONTH LIMITED WARRANTY Audiovox Electronics Corporation (the “Company”) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 12 months from the date of original purchase, such defect(s) will be repaired or replaced (at the Company’s option) without charge for parts and repair labor.
