User's Manual

PMG1006-B20A User’s Guide 15
CHAPTER 4
LAN
4.1 Overview
This chapter describes how to configure LAN settings.
A Local Area Network (LAN) is a shared communication system to which many computers are
attached. A LAN is a computer network limited to the immediate area, usually the same building or
floor of a building.
4.2 IP
Click Network > LAN to open the IP screen. Use this screen to set the Local Area Network IP
address and subnet mask of your GPON Device.
Figure 8 Network > LAN > IP
The following table describes the fields in this screen.
Table 4 Network > LAN > IP
LABEL DESCRIPTION
IP Address Enter the LAN IP address you want to assign to your GPON Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
IP Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your GPON Device automatically computes the
subnet mask based on the IP address you enter, so do not change this field unless you
are instructed to do so.
Apply Click Apply to save your changes back to the GPON Device.
Cancel Click Cancel to begin configuring this screen afresh.