Operation Manual

Chapter 3 Installing the Utility

PLA Series User’s Guide

11 Click Finish to exit the wizard.

Figure 9 Installation Complete

Note: You may be asked to restart your computer when the installation is complete. Click

“Yes” to restart your computer. If you select “No, I will restart my computer later”,

you will not be able to launch the utility until after a restart of your computer.

3.2 Macintosh (Mac)

This section uses the Mac OS X 10.8 screens as an example to show you how to install the Mac

vesion of the ZyXEL PLA Series Configuration utility.

3.2.1 Supported OSs

At the time of writing, the following Mac OSs support the ZyXEL PLA Series Configuration utility:

•Mac OS X 10.6

•Mac OS X 10.7

•Mac OS X 10.8

3.2.2 Installing the Utility

Follow the steps below to install the ZyXEL PLA Series Configuration utility on your Mac

computer.

1 Insert the included CD into your computer’s CD-ROM drive.