User manual

Chapter 50 System
ZyWALL USG 300 User’s Guide
829
50.6.5 Service Control Rules
Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or
SNMP screen to add a service control rule.
Figure 545 Configuration > System > Service Control Rule > Edit
The following table describes the labels in this screen.
50.6.6 Customizing the WWW Login Page
Click Configuration > System > WWW > Login Page to open the Login Page
screen. Use this screen to customize the Web Configurator login screen. You can
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
Table 240 Configuration > System > WWW > Service Control (continued)
LABEL DESCRIPTION
Table 241 Configuration > System > Service Control Rule > Edit
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in
this screen.
Address
Object
Select ALL to allow or deny any computer to communicate with the
ZyWALL using this service.
Select a predefined address object to just allow or deny the computer
with the IP address that you specified to access the ZyWALL using this
service.
Zone Select ALL to allow or prevent any ZyWALL zones from being accessed
using this service.
Select a predefined ZyWALL zone on which a incoming service is allowed
or denied.
Action Select Accept to allow the user to access the ZyWALL from the specified
computers.
Select Deny to block the user’s access to the ZyWALL from the specified
computers.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving