User manual
Chapter 17 Zones
ZyWALL USG 300 User’s Guide
406
17.3 Zone Edit
The Zone Edit screen allows you to add or edit a zone. To access this screen, go
to the Zone screen (see Section 17.2 on page 405), and click the Add icon or an
Edit icon.
Figure 311 Network > Zone > Add
The following table describes the labels in this screen.
Table 101 Network > Zone > Edit
LABEL DESCRIPTION
Name For a system default zone, the name is read only.
For a user-configured zone, type the name used to refer to the zone. You
may use 1-31 alphanumeric characters, underscores(
_), or dashes (-),
but the first character cannot be a number. This value is case-sensitive.
Block Intra-
zone Traffic
Select this check box to block network traffic between members in the
zone.
Member List Available lists the interfaces and VPN tunnels that do not belong to any
zone. Select the interfaces and VPN tunnels that you want to add to the
zone you are editing, and click the right arrow button to add them.
Member lists the interfaces and VPN tunnels that belong to the zone.
Select any interfaces that you want to remove from the zone, and click
the left arrow button to remove them.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.