User manual

Chapter 13 Interfaces
ZyWALL USG 300 User’s Guide
309
Enable
Interface
Select this to enable this interface. Clear this to disable this interface.
Interface
Properties
Interface
Name
Specify a name for the interface. It can use alphanumeric characters,
hyphens, and underscores, and it can be up to 11 characters long.
Base Interface Select the interface upon which this PPP interface is built.
Note: Multiple PPP interfaces can use the same base interface.
Description Enter a description of this interface. It is not used elsewhere. You can
use alphanumeric and
()+/:=?!*#@$_%- characters, and it can be
up to 60 characters long.
Connectivity
Nailed-Up Select this if the PPPoE/PPTP connection should always be up. Clear
this to have the ZyWALL establish the PPPoE/PPTP connection only
when there is traffic. You might use this option if a lot of traffic needs
to go through the interface or it does not cost extra to keep the
connection up all the time.
Dial-on-
Demand
Select this to have the ZyWALL establish the PPPoE/PPTP connection
only when there is traffic. You might use this option if there is little
traffic through the interface or if it costs money to keep the
connection available.
ISP Setting
Account Profile Select the ISP account that this PPPoE/PPTP interface uses. The drop-
down box lists ISP accounts by name. Use Create new Object if you
need to configure a new ISP account (see Chapter 47 on page 787 for
details).
Protocol This field is read-only. It displays the protocol specified in the ISP
account.
User Name This field is read-only. It displays the user name for the ISP account.
Service Name This field is read-only. It displays the PPPoE service name specified in
the ISP account. This field is blank if the ISP account uses PPTP.
IP Address
Assignment
Get
Automatically
Select this if this interface is a DHCP client. In this case, the DHCP
server configures the IP address automatically. The subnet mask and
gateway are always defined automatically in PPPoE/PPTP interfaces.
Use Fixed IP
Address
Select this if you want to specify the IP address manually.
IP Address This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
Metric Enter the priority of the gateway (the ISP) on this interface. The
ZyWALL decides which gateway to use based on this priority. The
lower the number, the higher the priority. If two or more gateways
have the same priority, the ZyWALL uses the one that was configured
first.
Table 63 Configuration > Network > Interface > PPP > Add (continued)
LABEL DESCRIPTION