User's Manual
Table Of Contents
- NBG6515
- User’s Guide
- Technical Reference
- Wireless LAN
- 11.1 Overview
- 11.2 What You Can Do
- 11.3 What You Should Know
- 11.4 General Wireless LAN 2.4G/5G General Screen
- 11.5 General Wireless LAN 2.4G/5G Security Screen
- 11.6 MAC Filter
- 11.7 Wireless LAN Advanced Screen
- 11.8 Quality of Service (QoS) Screen
- 11.9 WPS Screen
- 11.10 WPS Device Screen
- 11.11 Scheduling Screen
- 11.12 Guest WLAN Screen
- IPv6
- WAN
- LAN
- DHCP Server
- Network Address Translation (NAT)
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Bandwidth Management
- Remote Management
- Universal Plug-and-Play (UPnP)
- USB Media Sharing
- Maintenance
- Troubleshooting
- Wireless LAN
Chapter 11 Wireless LAN
NBG6515 User’s Guide
95
Click Network > Wireless LAN 2.4G/5G > Guest WLAN. The following screen displays.
Figure 75 Network > Wireless LAN 2.4G/5G > Guest WLAN
The following table describes the labels in this screen.
Table 48 Network > Wireless LAN 2.4G > Guest WLAN
LABEL DESCRIPTION
Guest WLAN Setup
Guest WLAN Select Enable to activate the guest wireless LAN. Select Disable to turn it off.
Network
Name(SSID)
The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
Guest IP
Address
Type an IP address for the devices on the Guest WLAN using this as the gateway IP address.
Guest Subnet
Mask
Type the subnet mask for the guest wireless LAN.
Guest Start IP This field displays the first IP address of guest wireless LAN.
Guest End IP This field displays the last IP address of guest wireless LAN.
Security
Security Mode Select Static WEP, WPA-PSK, WPA2-PSK to add security on this wireless network. The
wireless clients which want to associate to this network must have same wireless security
settings as this device. After you select to use a security, additional options appears in this
screen. Section 11.5 on page 85 for detailed information on different security modes. Or you
can select No Security to allow any client to associate this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Apply Click Apply to save your changes to NBG.
Reset Click Reset to begin configuring this screen afresh.