User's Manual

Chapter 9 Universal Repeater Mode
NBG6515 User’s Guide
70
Figure 52 Network > Wireless LAN 5G > AP Select
The following table describes the labels in this screen.
Table 34 Network > Wireless LAN 5G > AP Select
LABEL DESCRIPTION
NO. This is the index number of the APs.
Select Use the radio button to select the wireless device to which you want to connect.
SSID This displays the Service Set IDentity of the wireless device. The SSID is a unique name
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
MAC This displays the MAC address of the wireless device.
Channel This displays the channel number used by this wireless device.
Mode This displays which IEEE 802.11b/g/n wireless networking standards the wireless device
supports.
Security Mode This displays the type of security configured on the wireless device. When No Security is
shown, no security is configured and you can connect to it without a password.
Strength This displays the strength of the wireless signal. The signal strength mainly depends on
the antenna output power and the distance between your NBG and this device.
RSSI This shows the received signal strength indicator (RSSI), that is, the received signal
strength in dBm.
Setup repeater
manually
Select this to setup the AP manually.
SSID If Setup repeater manually is selected, use this field to type the SSID of the AP. This is
useful when the AP’s SSID is hidden.
WPS Click WPS to start WPS-aware wireless station scanning and the wireless security
information synchronization.
Refresh Click this to search for available wireless devices within transmission range and update
this table.
Next Click this to continue.