User's Manual
Table Of Contents
- NBG6503
- User’s Guide
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation (NAT)
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Bandwidth Management
- Remote Management
- Universal Plug-and-Play (UPnP)
- Maintenance
- Troubleshooting
- IP Addresses and Subnetting
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 10 Wireless LAN
NBG6503 User’s Guide
98
The following table describes the labels in this screen.
Table 41 Network > Wireless LAN 2.4G > WDS
LABEL DESCRIPTION
WDS Setup
Basic Settings Select the operating mode for your Router.
• AP + Bridge -
The Router functions as a bridge and access point simultaneously.
• Bridge - The Router acts as a wireless network bridge and establishes wireless links with
other APs. You need to know the MAC address of the peer device, which also must be in
bridge mode. The Router can establish up to five wireless links with other APs.
Local MAC
Address
This is the MAC address of your Router.
Phy Mode Select the Phy mode you want the Router to use. This dictates the maximum size of packets
during data transmission.
Remote MAC
Address
This is the MAC address of the peer device that your Router wants to make a bridge
connection with.
You can connect to up to 4 peer devices.
Security
EncrypType Select whether to use WEP, TKIP or AES encryption for your WDS connection in this field.
Otherwise, select No Security.
EncrypKey The Encryp key is used to encrypt data. Peers must use the same key for data transmission.
Apply Click Apply to save your changes to Router.
Cancel Click Cancel to reload the previous configuration for this screen.