User`s guide

IES-612-51 User’s Guide
295
CHAPTER 47
MAC Commands
This chapter describes how to configure the IES-612-51’s MAC commands.
47.1 MAC Filter Commands
Use the MAC filter to control from which MAC (Media Access Control) addresses frames can
(or cannot) come in through a port.
Table 109 MAC Filter Command Summary
COMMAND DESCRIPTION P
switch mac filter show [portlist] Displays the MAC filtering status (V for
enabled, - for disabled) and the fixed
source MAC addresses on the specified
xDSL port(s) or on all xDSL ports if no
port is specified.
M/L
switch mac filter enable [portlist] Turns on the MAC filtering feature on the
specified xDSL port(s) or on all xDSL
ports if no port is specified.
H/H
switch mac filter disable [portlist] Turns off the MAC filtering feature on the
specified xDSL port(s) or on all xDSL
ports if no port is specified.
H/H
switch mac filter mode <port>
<accept|deny>
Sets whether the IES-612-51 allows or
blocks access for the MAC addresses
you specify.
H/H
switch mac filter set <port> <mac>
[mac] [mac]...
Adds an allowed source MAC address on
the specified xDSL port.
mac: The source MAC address in
"00:a0:c5:12:34:56" format.
H/H
switch mac filter delete <port> <mac>
[mac] [mac] ...
Removes a configured source MAC
address from the xDSL port that you
specify.
mac: The source MAC address in
"00:a0:c5:12:34:56" format.
H/H
statistics mac Displays current MAC address forwarding
table.
M/L