Operation Manual

Reference [Mixer]
ZOOM MRS-1608
78
DRUM
BASS
12345678 9/10 11/12 13/14 15/16
MASTER
Recorder section
Track mixer
Rhythm section
From directly after
[MASTER] fader
To directly before
[MASTER] fader
To master
track
MASTER OUTPUT
From master track
Track 1
Track 2
Track 3
Track 4
Track 5
Track 6
Track 7
Track 8
Tracks 9/10
Tracks 11/12
Tracks 13/14
Tracks 15/16
Master track
Bass program
Drum kit
This section explains how to adjust the sensitivity for
signals input from the INPUT jacks 1 – 8 and GUITAR/
BASS INPUT jacks 1/2, and how to send them to tracks
in the recorder section.
1.
Make sure that the instrument or mic that
you want to record is connected to the
respective INPUT or GUITAR/BASS INPUT
jack.
NOTE
You can use either GUITAR/BASS INPUT jack 1 or INPUT
jack 1, and either GUITAR/BASS INPUT jack 2 or INPUT jack
2. If both jacks are connected, the GUITAR/BASS INPUT
jacks 1/2 are given priority.
2.
From the main screen, press the [ON/OFF]
key of the input to which the instrument or
microphone is connected, so that the key is
lit in red.
Input selection is performed with the [ON/OFF] keys in the
input section. If you press an [ON/OFF] key while another
key is already lit, the previous key goes out and the new key
lights up. While the key is lit, the input is active.
Normally, up to two keys can be activated simultaneously.
To activate two inputs, hold down one [ON/OFF] key and
then press the other key. It is also possible to press two non-
adjacent [ON/OFF] keys together.
HINT
When the [8TRACK RECORDING] key is activated, the 8-
track recording mode becomes active, and up to eight inputs
can be used simultaneously. Each input can then be
switched on or off individually.
3.
While playing your instrument, turn the
[INPUT] control or the [GUITAR/BASS
INPUT] control for the input selected in
step 2, to adjust the input sensitivity.
Make adjustments so that the [PEAK] indicator flickers
slightly when you play your instrument at its loudest
volume.
4.
If you will be recording the sound through
the insert effect, press the [INPUT
SOURCE] key in the effect section and turn
the dial to set the insert position for the
effect to IN.
Assigning input signals to
recording tracks
1608E.book 78 ページ ２００４年４月１９日 月曜日 午前１０時４４分