Instruction Manual

Problem Possible Cause Corrective Action
Salt level too high. Too much salt has been added to pool. Backwash or partially drain pool and dilute
with fresh water until salinity returns to 3.0
gpl to 3.5 gpl.
Chlorine level too high. Electrolytic cell is manufacturing too much
chlorine.
Decrease the chlorine production rate
adjustment button (arrow button A).
See Section 5, Operating Instructions.
If chlorine output at the lowest setting
consistently provides for excessive
chlorine levels, decrease daily pump
operation time as much as necessary.
If chlorine output at lowest setting is still
excessive the Nature2 Fusion Soft system
is oversized for the pool.
“Service” indicator on. Low salt level in pool water. Test salinity. Add salt as described in
Section 4.6.
Cell requires cleaning. Refer to Maintenance Procedure for acid
wash cleaning. See Section 6.5, Step 2.
Cell not working properly after cleaning. Contactaqualiedservicerepresentative.
DC power cord not properly connected to the
cell.
Check connection. Check for dirt or
corrosion around DC cord contacts at cell.
Check Cell studs for same.
Flow/temp/salinity sensor not plugged in. Plugow/temp/salinitysensorinto
connector on power center printed circuit
board (Cycle Power).
Water temperature too low. Winterize your pool. See Section 6.7,
Winterizing.
All the above have been checked and
indicator light is still on.
Contactaqualiedservicerepresentative.
Salt level too low. Not enough salt added on start up. Add salt to pool, 3.0 gpl to 3.5 gpl. See
Section 4.6.
Heavy rainfall. Add salt to pool, 3.0 gpl to 3.5 gpl. See
Section 4.6.
Leak in pool. Repair pool.
Dirtyow/temp/salinitysensorcontactsor
faultyowsensor.
Removeandcleanow/temp/salinity
sensorcontacts.Checkow/temp/salinity
sensor cable for damage. See Section
6.6. Verify salinity with Myron “L” meter
calibrated for NaCl, titration test units, or
other salt meters. Please be aware that
salt test strips have a large variance in
readings (400 - 800 ppm).
Chlorine odor. Presence of excess chloramines (combined
chlorine).
Manually shock the pool following the
directions in Section 5.4.2 Shocking.
Cloudy water, slimy walls of pool. It has been six (6) months since present
cartridge was installed.
Brush pool, manually shock, adjust pH,
replacecartridge.Runltrationsystemfor
24 hours.
Combined algae and bacteria growth. Brush down the affected walls and follow
the directions in Section 5.4.2 Shocking.
Eye and/or skin irritation. Improper water balance. Balance the water to recommended levels
in Section 4.5.
Page 40
ENGLISH
Zodiac
®
Nature
2
®
Fusion soft
|
Installation and Operation Manual