Installation Guide

StudSensor
™
HD
55
Zircon Corporation
|
1580 Dell Avenue
|
Campbell, CA 95008
|
[e-mail]
|
www.zircon.com
|
408-963-4550
|
800-245-9265
© 2017 DeepScan, SpotLite, StudSensor, WireWarning, and Zircon are trademarks or registered trademarks of Zircon Corporation • C/N 2198 Rev B 03/17
SPECIFICATIONS
EDGE FINDING
ZirconTV
ZirconCorporation
ZirconTools
ZirconToolPro
ZirconTools
Dimensions 6.78 in. H x 2.84 in. W x 1.47 in. D
(172 mm x 72 mm x 37 mm)
Weight 4.6 oz. (131 g) without battery
Battery Type 9V alkaline, required
Position Up to a depth of ¾ in. (19 mm):
Accuracy* Typically within ¹⁄₈ in. (3 mm) using
the dual scan and mark procedure
Up to a depth of 1 ½ in. (38 mm):
Typically within
3
⁄16 in. (5 mm) using
the dual scan and mark procedure
Depth* StudScan mode: Up to ¾ in. (19 mm)
DeepScan
®
mode: Up to 1 ½ in. (38 mm)
WireWarning
®
Typically 90-250 V at 50-60Hz within 6 in.
Position (152 mm) of a hot unshielded wire in drywall
Accuracy*
WireWarning
®
In typical wall with Romex
®
wiring,
Depth* wire can be detected up to 2 in. (51 mm) deep
Operating 20° to 105°F (-7° to 41°C)
Temperature
Storage -20° to 150°F (-29° to 66°C)
Temperature
Humidity 5-90% RH (non-condensing)
Water Splash and water resistant,
Resistance not waterproof
*NOTE: Sensing depth and accuracy can vary due to moisture, content of
materials, wall texture, paint, etc. Not recommended for use on lath and
plaster. Indoor use only.
WireWarning
®
Detection
Scan Thick Walls
for Studs
Find Stud Edges
Find Wood or
Metal Studs
The StudSensor
™
HD
55 deep-scanning stud finder boasts more design
innovations by Zircon. Featuring an enhanced LCD display, it debuts a new
Target Spotlight that illuminates on-screen when you’ve found the edge of a
stud. Select from two stud scan modes to find the edges of wood and metal
studs to securely anchor mirrors, shelves, and cabinets to the wall while also
avoiding live AC electrical wiring.
Deep-Scanning Stud Finder with SpotLite
®
Pointer and WireWarning
®
Detection
•
StudScan mode locates the edges of wood or metal
studs up to ¾ in. (19 mm) deep
•
DeepScan
®
mode doubles the scanning depth
to 1½ in. (38 mm) deep
•
WireWarning
®
detection indicates the presence
of live, unshielded AC electrical wiring up to
2 in. (51 mm) deep
•
Zircon's patented "over-the-stud" indication alerts
the user to start the scan in a new location if scanning
begins over a stud
• Enhanced LCD display with Target Spotlight indicates
approaching stud edge and illuminates when stud edge
is detected
•
SpotLite
®
Pointer shines an arrow-shaped light on the
wall to clearly indicate the edge of the stud
• Translucent base and illuminated "V" marker groove
for more accurate marking of stud edge location
• Rubber handle for non-slip grip