A S S E M B LY I N S T R U C T I O N S Huntersville Vinyl Screen Kit 2 Pack (36”W x 48”H) 36 in 14 3/4 in 47 1/2 in 7 7/8 in 7/8 in 14 3/4 in 1 1/2 in 7/8 in 12 in 4 in Ground 31 3/4 in 33 1/4 in If necessary, this enclosure can be trimmed down vertically to fit your custom space. Use a fine toothed circular or hack saw. Rails will need to be re-spaced and configured accordingly Ver 1.
G E N E R A L I N F O R M AT I O N Please read through before starting assembly. IMPORTANT: CHECK THE INSIDE OF THE LARGER PIECES IN YOUR BOX FOR OTHER MATERIALS PACKED INSIDE. Check Box for These Contents In the event of missing or defective parts please call our customer service department at 1 877 234 6196 (Mon. to Fri. 8:00 AM to 4:00 PM EST). 1. 2. 3. 4. 5. 6. 7. 8. 9. 10.
STEP ONE 1 Identify the top/middle and bottom rails (Bottom rails’ holes are on only one side for pickets) Pressure fit the three loose rail end caps into the ends of each rail. 2 1 Middle and Top Rail (Picket holes on both sides) Position the two posts as illustrated and slide the top and middle rails down over the posts - towards the locking tabs - until the pre-drilled holes in rails are aligned with the the pre-drilled holes in both posts.
STEP T WO 1 Align the pre-drilled holes on the rail and posts, then slide the post anchors all the way up through the enlarged holes on the bottom of the rail until they bottom out against the posts and fasten together with a total of four 3/4” screws. 2 One by one, guide the numbered pickets down through the three horizontal rails. Push down into the horizontal rail until the pickets lock into place.
STEP THREE 1 Install Screen into Ground 1 Move the screen to its final location and identify the location of posts. 2 Attempt to push the unit into the ground as illustrated Optionally: 1. If your ground is too hard, loosen the top 6” or 7” of the ground with a claw hammer as illustrated. 2. Add water to loosened soil 3. Use a block of wood to the protect the top of post and gently hammer the post into the ground.
STEP THREE Install Screen into Ground (Continued) 3 Level the screen as necessary and backfill excavated dirt and tamp as necessary. 3 Level If your ground is really hard, you may need to dig a hole large enough to accomodate one post from each panel into the same hole - Approximately 8” in diameter and 10” deep. Backfill and compact the dirt.
STEP FOUR Fasten Joiner Clips 1 Fasten screens together by using joiner clips as illustrated. 2 Fasten the opposite end of the joiner clip as illustrated.
STEP FIVE Fasten Post Caps 1 Push the post caps down over the posts to lock into place. 1 8 www.zippity-outdoor.com 6935 Reames Rd. Ste. K.
