User manual

OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at Seite 17
HAND-DRUCKSPRÜHER / PRESSURE SPRAYER ZI-HDS 8Lite 17
12 OPERATION
Please check the product contents (see capture 10.1) immediately after receipt for any eventual
transport damage or missing parts. Claims from transport damage or missing parts must be placed
immediately after initial machine receipt and unpacking before putting the machine into operation.
Please understand that later claims cannot be accepted anymore
12.1 Assembly
Insert the spray rod into the switch and tighten the
fastening nut
12.2 Operation instructions
NO T IC E
The chemical for application in this Sprayer shall not exceed 40°C
Trial spraying with clean water and a check of tank, hose, spray head
for possible leakage are required prior to operation.
The preparation of chemical shall follow the instructions and formula
furnished by the pesticide manufacturer. Unauthorized altering of the
dilution rate of chemical is prohibited, which may either endanger the
human being and animal, or result in the failure of pest control.
Upon the finish of operation, you shall change clothes and wash those
exposed part of body such as hands and face. In case of highly toxic
pesticide and germicide, a shower after operation is required to
ensure safety.
12.3 Operation
1. Open the tank:
While in operation, hold the handle and press
it down forcedly to move its lower part into
the groove of guide holder. Turn the handle to
dismount the pump set.
2. Fill the tank:
Fill the tank up to the prescribed quantity and
put the pump back on.