User's Manual

30
Click and hold the left mouse button to start drawing, and then release the button to 3)
complete drawing.
 Double-click the map to enter full screen display to draw the line more accurately.
 Click Clear to clear the line you drew.
Enter the actual measured length of the line you drew in the Line Length input box 4)
and then click Calculate Map Size.
The system will automatically get the map width and height.
Click Next. 5)
Radar Positioning
Drag the end points of the yellow sector on the map to adjust the radar orientation. Step 1
 When the dotted line points to the right horizontally, it is considered as 0°. The
degree increases clockwise, and you can also adjust degree value by clicking /
or entering a number.
 Double-click the map to enter full screen to position the radar more accurately.
Radar positioning Figure 4-14
Enter installation height of the radar in Altitude box. Step 2
Enter height of the radar center (front side); otherwise the camera-radar linkage effect will
be reduced.
Click Next. Step 3
(Optional) Radar Calibration
Radar calibration is only for Radar-PTZ Linkage, and you can skip this setting as needed.
Select a PTZ camera in PTZ Camera List, and then enter the username and password used Step 1
to log in to the web interface of the camera.