User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
87
Preconditions
The device is connected to the Internet.
DMSS Client is downloaded and installed on you mobile phone.
Steps
Select PLATFORM > P2P
The P2P interface is displayed, see Figure 4-70.
P2P
Click to enable P2P function.
Use DMSS Client to scan the QR code under Device SN to add the device to DMSS
Client.
CAUTION
Scan the QR code on the actual interface of Device.
Click OK.
After configuration is complete, the Status box shows Online, meaning the P2P
registration is successful.
Adding Device into Mobile Phone Client
To use this function, take adding device into mobile phone client as an example.
On your mobile phone, download the application.
After the installation, run the client, select Remote Monitoring and go to the main
menu.
Add the device to the mobile client.