User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
84
4.6.2.4 Configuring Network Testing Settings
You can test the network status and load.
4.6.2.4.1 Testing Network Status
You can test the network status and view the average delay and packet loss rate.
In the main menu, select Info > Network > Net Test
The NET TEST interface is displayed. See Figure 4-67.
Net test
In the Destination IP box, enter the IP address, and then click Test.
After testing is completed, the test result is displayed. You can view the evaluation for
average delay, packet loss rate, and network status.
4.6.2.4.2 Testing Network Load
You can view all the network information of the device, such as MAC address, connection
status, IP address, data receiving speed and sending speed.
In the main menu, select Info > Network > Net Load
The NET LOAD interface is displayed. See Figure 4-68.