User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
65
Email
Click to enable email function.
Configure TCP/IP parameters. For details, see Table 4-13.
Table 4-13 Email setting parameters description
Name
Description
SMTP Server Configure the address of SMTP (Simple Mail Transfer Protocol) server.
Port Enter the port value of SMTP server.
Username
Enter the user name and password of SMTP server.
Password
Receiver
Receiver’s mail address You can enter up to three email addresses
separated by colons
Sender
Select sender, and configure email address.
Email
Title
You can enter no more than 63 characters in Chinese, English, and Arabic
numerals
Encrypt In the Encrypt list, select an encryption type from NONE, SSL, and TLS.
Interval
This is the interval that the system sends an email for the same type of
alarm event, which means, the system does not send an email upon any
alarm event
The interval ranges from 0 to 3600 seconds. 0 means that there is no
interval
NOTE
This setting helps to avoid the large amount of emails caused by frequent
alarm events