User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
10
Hangers Installation Dimension Diagram (mm)
Installation
When you receive the Device, unpack the box to check the Device appearance and structures,
and then install the SIM card, SD card, and HDD.
NOTE
Before the installation is complete, make sure the Device is disconnected from power, and
do not plug or unplug components when the power is connected.
When installing and taking out HDD, the Device electronic lock must be in "unlocked"
status. After the installation is complete, the Device electronic lock must be in "locked"
status before powering on the Device.
2.3.1 Installing HDD
Gently press the left front cover.
The left front cover automatically opens.
Use a particular key to unlock the door.