User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
134
Name
Description
Auto/Manual/Stop
Select the recording mode, including Manual, Auto, and Stop
Manual: Top priority. When the Manual check box is selected, the
system keeps general recording for 24 hours for the corresponding
channel
Auto: The system starts recording according to the record type (such
as general alarm, motion detect, and system alarm) and recording
time
Stop: Do not record
Enable/Stop
Enable or disable the scheduled snapshot for the corresponding
channels
Click Save.
5.3.5 Set up the storage plan
5.3.5.1 Configuring Recording Schedule
The default recording setting is 24 hours recording for all channels. You can configure the
record type and recording time according to your actual situation.
Preconditions
The auto recording is enabled for the corresponding channel. For details, see “5.3.4
Configuring Record Settings.”
Steps
Select Setup > Storage Management > Storage Plan > Record.
The Record interface is displayed. See Figure 5-16.