User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
110
Modify User
Click after Modify Password to enable the function of modifying the
password.
Type old password, new password. Then type your new password again to confirm
it.
NOTE
The new password can be set from 8 characters through 32 characters and
contains at least two types from number, letter and special characters
(excluding ' " ; : Please set a high security password according to the prompt of
password strength.
The user with Accout authority can also modiy the password of other users.
(Optional) Set up a reserved mobile phone.
Setting up a reserved phone number lets you reset the login password of the admin
account if it was lost. See4.8.2.2Reset Password.
Click OK.
4.8.2.2 Reset Password
You can reset the password through the reserved phone number when the password for the
admin account is lost.
Preconditions
The password reset function has been enabled and the reserved mobile phone has been set.
NOTE
When the password reset function is disabled, the password can be reset through the
password protection question in the local interface. If the password protection question is not
set, all you can do is to have the default setting restored through the hardware reset function.