User Manual

8
6 FAQ
Radar is a professional product of high technology and high sensitivity. Please read the user’s
manual carefully before you use.
Bug
Fix
There is no output, no
response, after I connected
the power to the device.
 Check power connection and voltage
 Check power positive end and the negative end connection
are right or not.
 Check the communication cable connection is OK or not. The
cable connection SN is right or not.
 Check the COM can get the applications properly or not.
 Check application COM setup is OK or not.
I just got some disordered
code
 Check the communication cable connection is OK or not. The
cable connection SN is right or not.
 Make sure there is no strong interference on the
communication cable.
 Check COM baud rate is OK or not.
There is no speed when a
vehicle passed.
 Check the radar installation angle. Make sure it is facing the
corresponding lane.
 The radar installation angle is within the reasonable range.
 Check the distance from the radar to the object is in the
specified range.
 The radar sensitivity is too low.
There is a speed but there is
no vehicle passing by.
 There is strong electromagnetism interference or rotation
object.
 Check the radar installation angle, whether there is
interference from the neighboring lane.
 The radar sensitivity is too high.
It missed vehicle
 Check the radar installation angle. Make sure it is facing the
corresponding lane.
 Check the distance from the radar to the object is in the
specified range,.
 The radar sensitivity is too low.
The camera does not snap
 Check the communication cable connection is OK or not. The
cable connection SN is right or not.
 Check camera protocol is right or not.
 Check the RS232 setup; make sure the baud rate setup is
right.
 The camera snap function is enabled.
 The radar working mode such as min object interval, detect
direction, sensitivity is right.