Use and Care Manual

9
A
C
B
15”
4-3/4”
(36”, 42”)
11-13/16”
(48”,54”,60”)
17-11/16”
(36”) 25-1/4”, (42”) 31-3/16”
(48”) 19-1/16”, (54”) 25-1/16”
(60”) 30-7/8”
C/L
24" min.
2
1
Duct Cover
Bracket
(48”) 37-3/16”, (54”) 43-1/8”, (60”) 49”
Installation – Mounting the Range Hood
1. MeasurefromrangetoptohoodbottomandmarklineA.(24”
minimumfromrangetop).
2. Plumandmarkcenterline.
3. MarkmountingheightlineB.(15”fromlineA)
4.MarkmountingheightlineC.(4-3/4”fromlineA)
5. MarkmountingspreadfromC/LonlineBandCaccordingto
diagram.
6. Fasten(2)6#x2”screwsintostudsonlineB.Fasten(2)or(4)
6#x2”screwsintostudsonlineC.Donotfastenscrewsallthe
way, leave approxamately 3/8” exposed. Note: wood blocking
may need to be added behind the drywall if no studs are
present. Wall anchors may also be used but check local
codes for compliance. Failure to use suitable wall anchors
and screws to hold the weight of the hood could result in
personal injury or damage to cooking surface or counter.
7.Installroundductcollarwithbackdraftdampertotoporrearof
hoodby(4)M4x8screws.
8. If ducting hood through rear of hood body, cut duct access hole in
wall and prepair ducting.
9. Hanghoodontowallmountedscrewsandtighten.(FIG.A#1)
10.Centerandattachductcoverbrackettowallbelowceilingorso󰀩t
using(2)6#x11/2”screws.
11.Prepairandconnectelectricalandinstallductworkandducttape.
12.Poweruphoodandcheckforleaksaroundducttape.
13. Place telescopic duct covers onto hood and extend inner
(top)ductcoverupwardsandsecuretoductcoverbracket
using(2)M4x8screws.
CAUTION: At least two installers are required
due to the weight and size of the hood.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Cable Lock
Warning:
Forpersonalsafety,removehousefuseoropencircuitbreakerbeforebeginninginstallation.Donot
use extension cord or adaptor plug with this appliance.
Follow national electrical codes or prevailing local codes and ordinances.
Electrical Supply:
This appliance requires a 120V 60Hz electrical supply, and connected to an individual, properly
goundedbrandcircuit,protectedbya15or20amperecircuitbreakerortimedelayfuse.Wiringmust
be 2 wire w/ground. Please refer to Electrical Diagram labeled on product.
Cable Lock:
Acablelockingconnector(notsupplied)mightalsoberequiredbylocalcodes.Checkwithlocal
requirements and codes, purchase and install appropriate connector if necessary.