User's Manual

3 - 6 TC8000 User Guide
Figure 3-6 Imager Pick List Mode with Multiple Bar Codes
5. Release the trigger.
Bar Code Capture with Camera
To read a bar code, a scan-enabled application is required. The TC8000 contains the DataWedge application that
allows the user to enable the scanner to decode bar code data and display the bar code content. See DataWedge
on page 3-14 for more information on launching DataWedge.
1. Launch a scanning application.
2. Point the camera window at a bar code.
3. Press and hold the trigger. By default, a preview window appears on the screen.
Figure 3-7 Camera Scanning
NOTE When Picklist mode is enabled, move the TC8000 until the bar code is centered under the red target on
the screen.
Review Copy