User's Manual
Table Of Contents
- Revision History
- Table of Contents
- About This Guide
- Chapter 1 Getting Started
- Chapter 2 Using the TC8000
- Chapter 3 Data Capture
- Introduction
- Status LED
- Laser Scanning
- Imaging
- Digital Camera
- Scanning Considerations
- Bar Code Capture with Laser Scanner
- Bar Code Capture with Imager
- Bar Code Capture with Camera
- Bar Code Capture with RS507 Hands-Free Imager
- Pairing the RS507 Hands-Free Imager Using SSI
- Pairing the RS507 Hands-Free Imager Using Bluetooth HID
- Hands Free Scanning
- Ergonomic Recommendations During Scanning
- DataWedge
- Pairing the RS507 Hands-Free Imager using HID
- Pairing the RS507 Hands-Fee Imager Using SSI
- Chapter 4 Wireless
- Chapter 5 Applications
- Chapter 6 Accessories
- Accessories
- 2-Slot Charge Only Cradle
- 5-Slot Charge Only Cradle
- 5-Slot Charge Only Cradle with Battery Charger
- 5-Slot Ethernet Cradle
- 5-Slot Ethernet Cradle with Battery Charger
- 4-Slot Battery Charger
- USB and Charging Cable
- Quick Disconnect Audio Adapter
- 3.5 mm Audio Adapter
- Desktop Stand
- Cart Mount
- Quick-Draw Soft Holster
- Presentation Holster
- Stylus
- Chapter 7 Maintenance and Troubleshooting
- Appendix A Specifications
- Index
Getting Started 1 - 5
Figure 1-3 Battery Installation
2. Snap battery into place.
Charging the Battery
Before using the TC8000 for the first time, charge the battery using a cable or a cradle with the appropriate power
supply. For information about the accessories available for the TC8000, see Chapter 6, Accessories.
•
4-Slot Battery Charger
•
2-Slot USB Charge Cradle
•
5-Slot Charge Only Cradle
•
5-Slot Ethernet Cradle
•
5-Slot Charge Only Cradle with 4-Slot Battery Charger
•
5-Slot Charge Only Cradle with 4-Slot Battery Charger.
The 6,400 mAh battery fully charges in approximately six hours at room temperature.
Charge batteries in temperatures from 0 °C to 40 °C (32 °F to 104 °F). The TC8000 or accessory always performs
battery charging in a safe and intelligent manner. At higher temperatures (e.g. approximately +37 °C (+98 °F)) the
TC8000 or accessory may for small periods of time alternately enable and disable battery charging to keep the
battery at acceptable temperatures. The TC8000 or accessory indicates when charging is disabled due to
abnormal temperatures via its LED.
1. To charge the main battery, connect the charging accessory to the appropriate power source.
2. Insert the TC8000 into a cradle or attach to a cable. The TC8000 turns on and begins charging. The
Charging/Scan LED blinks amber while charging, then turns solid green when fully charged.
Review Copy