User Manual
Table Of Contents
- Table of Contents
- Proprietary Statement
- Declaration of Conformity
- Warranty Information
- Preface
- Introduction
- Printer Setup
- Printer Operation
- Configuration
- RFID Guidelines
- Routine Care and Adjustments
- Troubleshooting
- Data Connections
- Specifications
- Index
Printer Operation
Load Roll Media
R4Mplus User Guide 33
Adjust Media Alignment for Rewind Option
The instructions below apply only if the printer has a Rewind option. The liner should be
installed flush against the backplate of the rewind spindle to prevent the media/backing from
winding too loosely. See Figure 20.
Do the adjustments in the order given. Do only what is needed to solve the problem.
To adjust the Media Alignment for Rewind Mode, complete these steps:
1. Turn the adjustment dial clockwise to move the media toward the mainframe.
2. Turn the dial counter clockwise to move the media away from the mainframe.
Figure 20 • Rewind Option Adjustment Dial
1
Rewind Spindle Backplate
2
Rewind Spindle
3
Adjustment Dial
4
Printhead Assembly
1
2
4
3