User's Manual

Regulatory Guide (RG) Rev. A
Zebra Technologies Corporation Page 5 of 9
Zebra Confidential Restricted
4. Radio Frequency Interference Requirements- Canada
CAN ICES-3 (B)/NMB-3(B)
Radio Transmitters
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radio électrique subi même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Label Marking: The Term ‘IC:’ before the radio certification only signifies that Industry Canada technical specifications were met.
In accordance with the regulations of Industry Canada, this radio transmitter can operate with an antenna of a type
and a maximum gain (or lower) approved for the transmitter by Industry Canada. With the aim of reducing the risk of
radio interference to other users, the chosen antenna type and it gain should be selected so that the equivalent
isotropically radiated power (e.i.r.p.) does not exceed the intensity necessary for the establishment of a satisfactory
connection.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne
d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les
risques de brouillage radio électrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de
sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante.
This radio transmitter (CDR2G) has been approved by Industry Canada to operate with the antenna types listed below
and having a maximum gain allowable and the impedance required for each type of antenna. The antenna types not
included in this list, or whose gain is higher than the maximum gain indicates, are strictly prohibited for the operation of
the transmitter.