MSDS

ManualsBrandsZAR ManualsKitchen1-gal. Gloss Ultra Max Waterborne Oil-Modified Interior Polyurethane

MATERIAL SAFETY DATA SHEET

PRODUCT NAME: ZAR ULTRA MAX OMU – ALL GLOSS LEVELS HMIS CODES: H F R P

PRODUCT CODE: 360,361,362,364 1 0 0

SECTION 1 – MANUFACTURER IDENTIFICATON

MANUFACTURE’S NAME: UNITED GILSONITE LABORATORIES EMERGENCY PHONE: (800) 424-9300

ADDRESS: 1396 JEFFERSON AVENUE

SCRANTON, PA 18509 INFORMATION PHONE: (570) 344-1202

NAME OF PREPARER: R. BARAKO

DATE ISSUED: AUGUST 2013

SUPERSEDES: FEBRUARY 2012

SECTION II – HAZARDOUS INGREDIENTS/SARA III INFORMATION

OCCUPATIONAL EXPOSURE LIMITS VAPOR PRESSURE WEIGHT

HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV OTHER mmHg@TEMP PERCENT

WATER 7732-18-5 NOT ESTAB NOT ESTAB NOT ESTAB 1.0 (68F) 59

URETHANE ACRYLIC POLYMER PROPRIETARY NOT ESTAB NOT ESTAB NOT ESTAB N/A 30

*TRIETHYLAMINE 121-44-8 100 MG/M

4.1 MG/M

NOT ESTAB N/A 2

PROPYLENE GLYCOL 57-55-6 NOT ESTAB NOT ESTAB NOT ESTAB .220(68F) 1

TRIPROPYLENE GLYCOL METHYL

ETHER 25498-49-1 NOT ESTAB NOT ESTAB NOT ESTAB .020 (68F) 2

DIPROPYLENE GLYCOL BUTOXY

ETHER 29911-28-2 NOT ESTAB NOT ESTAB NOT ESTAB 0.06 (68F) 4

DIPROPYLENE GLYCOL MONO-

METHYL ETHER 34590-94-8 NOT ESTAB NOT ESTAB NOT ESTAB 0.3 (68F) 1

SILICON DIOXIDE (CHEMICALLY

PREPARED) 112945-52-5 /

7631-86-9 NOT ESTAB NOT ESTAB NOT ESTAB N/A 1

*INDICATES A CHEMICAL SUBJECT TO THE REPORTIN REQUIREMENTS OF SECTION 313 OF TITLE III AND OF 40 CFR 372

SECTION III – PHYSICAL/CHEMCIAL CHARACTERISTICS

BOILING RANGE: 212 (F) SPECIFIC GRAVITY (H20 =1) 1.06

VAPOR DENSITY: HEAVIER THAN AIR EVAPORATION RATE: SLOWER THAN ETHER

COATING VOC: DOES NOT EXCEED MAXIMUM VOC 250 G/L

SOLUBILITY IN WATER: SOLUBLE

APPEARANCE AND ODOR: CLEAR TO MILKY, TYPICAL AMINE ODOR

SECTION IV – FIRE AND EXPLOSION HAZARD DATA

FLASHPOINT: N/A METHOD USED: N/A

FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: NO DATA UPPER: NO DATA

EXTINGUISHING MEDIA: WATER, FOG, FOAM, CARBON DIOXIDE, DRY CHEMICAL, HALOGENATED AGENTS

SPECIAL FIRE FIGHTING PROCEDURES: CONTAINER MAY SWELL AND BURST DURING A FIRE DUE TO INTERNAL PRESSURE CAUSED BY

HEAT. THIS MAY CAUSE A SLIPPERY CONDITION ON FLOORS. THIS PRODUCT WILL NOT SUPPORT COMBUSTION UNLESS THE WATER HAS

EVAPORATED.

UNUSUAL FIRE AND EXPLOSION HAZARDS: IRRITATING AND TOXIC SUSTANCES WILL BE EMITTED UPON COMBUSTION, BURNING OR

DECOMPOSITION OF THE DRY SOLIDS. COMBUSTION PRODUCTS: CARBON OXIDES, NITROGEN OXIDES. WEAR SELF-CONTAINED BREATHING

APPARATUS WITH FULL FACEPIECE AND PROTECTIVE CLOTHING.

SECTION V – REACTIVITY DATA

STABILITY: PRODUCT IS STABLE

CONDITIONS TO AVOID: TEMPERATURES BELOW 32 (F) FOR STORAGE. TEMPERATURES BELOW 50 (F) FOR APPLICATION

Summary of content (3 pages)

PAGE 1
MATERIAL SAFETY DATA SHEET PRODUCT NAME: PRODUCT CODE: ZAR ULTRA MAX OMU – ALL GLOSS LEVELS 360,361,362,364 HMIS CODES: H 1 F 0 R 0 P SECTION 1 – MANUFACTURER IDENTIFICATON MANUFACTURE’S NAME: ADDRESS: UNITED GILSONITE LABORATORIES 1396 JEFFERSON AVENUE SCRANTON, PA 18509 EMERGENCY PHONE: (800) 424-9300 INFORMATION PHONE: NAME OF PREPARER: (570) 344-1202 R.
PAGE 2
INCOMPATIBILITY (MATERIALS TO AVOID): ACIDIC CONDITIONS WILL CAUSE THE URETHANE RESIN TO PRECIPITATE OUT OF SOLUTION HAZARDOUS DECOMPOSITION OR BYPRODUCTS: CARBON MONOXIDE. CARBON DIOXIDE AND OXIDES OF NITROGEN HAZARDOUS POLYMERIZATION: WILL NOT OCCUR SECTION VI – HEALTH HAZARD DATA INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE: VAPORS OF THIS PRODUCT CAN IRRITATE MUCOUS MEMBRANES, EYES, NOSE AND RESPIRATORY PASSAGES.
PAGE 3
This information is furnished without warranty, representation, inducement or license of any kind, except that it is accurate to the best of UGL’s knowledge, or obtained from sources believed by UGL to be accurate, and UGL does not assume any legal responsibility for use or reliance upon same. Before using any product, read the label.