EN User manual Washer Dryer ZKN 7147 J
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Automatic Drying programmes _ _ _ _ _ _ _ _ _ _ _ 10 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 Drying Hints _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 12 Personalisation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 13 Dai
• After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance. • Always be sure, that there is no water leakage from hoses and their connections after the installation.
Product description 1 Detergent dispenser drawer 2 Control panel 1 2 3 Door opening handle 4 Rating plate 5 Drain pump 6 Adjustable feet 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
Control panel On the following page there is a picture of the control panel. It shows the programme selector dial as well as the buttons, pilot lights and the display. These are presented by relevant numbers on the following pages.
Available options: Delay Start Super Quick The programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1 hour up to a maximum of 20 hours by means of this button. Short cycle for lightly soiled items or for laundry which needs only freshening up. We recommend you to reduce the fabrics loading. Extra Rinse This appliance is designed to save energy. If it necessary to rinse the laundry using an extra quantity of water (extra rinse), select this option.
• Incorrect option selection If an option which is not compatible with the set wash programme is selected, the message Err is displayed at the bottom of the display for a few seconds and the integrated red light of button 7 start flashing. • End of programme When the programme has finished the flashing zero ( light of button 7 go out and the door can be opened.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load Type of Laundry Options Synthetics 60° - 30° Main wash - Rinses Maximum spin speed at 900 rpm Max. load 4 kg - Reduced load 2 kg1) Synthetic or mixed fabrics: underwear, coloured garments, nonshrink shirts, blouses. SPIN RINSE HOLD SUPER QUICK EXTRA RINSE Easy iron 40° Main wash - Rinses Maximum spin speed at 900 rpm Max.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load Type of Laundry Options Sport Intensive 40° Prewash - Main wash - Rinses Maximum spin speed at 900 rpm Max. load 2,5 kg This programme is suitable for washing heavily soiled sport items. The appliance will add automatically a prewash phase before the main wash to eliminate mud stains. SPIN RINSE HOLD Rinses Maximum spin speed at 1400 rpm Max.
Automatic Drying programmes Type of Fabric Max Load Cupboard dry Suitable for items to put away without ironing Degree of Drying Cotton and linen (bathrobes, bath towels, etc) 4 kg Cupboard dry Suitable for items to put away without ironing Synthetics and mixed fabrics (jumpers, blouses, underwear, household linen) 3 kg Iron dry Suitable for ironing Cotton and linen (sheets, tablecloths, shirts, etc.
Removing stains Stubborn stains may not be removed by just water and detergent. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water. For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times.
Drying Hints Preparing the drying cycle As a dryer, the appliance works on the condensation principle. Therefore, the water tap must be open and the drain hose must drain water into a sink or into the drain pipe, even during the drying cycle. Attention! Before starting the drying programme, reduce the loads of washed laundry, in order to obtain good performances.
Personalisation Acoustic signals The machine is provided with an acoustic device, which sounds in the following cases: • at the end of the cycle • if there is a fault. By pressing the 4 and 5 buttons simultaneously for about 6 seconds, the acoustic signal is deactivated (except if there is a fault). By pressing these 2 buttons again, the acoustic signal is reactivated.
programme. (See "Washing programmes" for the maximum allowed spin speed). Press this button repeatedly to change the spin speed, if you want your laundry to be spun at a different speed. The relevant pilot light illuminates. Select the available options by pressing the buttons 5 and 6 Depending on the programme, different options can be combined. These must be selected after choosing the desired programme and before starting the programme.
If the pilot light 9 remains lit, this means that the machine is already heating or that the water level is too high. In any case, do not force the door! If you cannot open the door but you need to open it, switch the machine off by turning the selector dial to . After a few minutes the door can be opened. (Pay attention to the water level and temperature!). After closing the door, it is necessary to select the programme and options again and to press button 7.
If you wish to open the door before or during the anti-crease phase or to interrupt it, press any button or turn the programme selector dial to any programme po). sition (except 8. 9. position to switch Turn the selector dial to the the machine off. Remove the laundry from the drum. The different type of cottons (towelling, sheets, shirts, and so on) or any laundry items rolling up during the spinning phase may result in partial dryness.
Fluff in the fabrics During the WASHING AND/OR DRYING PHASE, certain types of fabric, such as sponge, wool, sweatshirt, could release fluff. The released fluff could stick to the fabrics during the next cycle. This drawback increases with technical fabrics. To prevent the fluff in your clothes, it is recommended: • To do not wash dark fabrics after you washed and dried light colored fabrics (new sponge, wool, sweatshirt especially) and vice versa.
• the appliance does not empty and/or spin; • the appliance makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump; • a problem with water draining is detected (see chapter “What to do if...” for more details). 1. 2. Warning! Disconnect the mains plug from the mains socket. Do not remove the filter while the appliance operates. Do not clean the drain pump if the water in the appliance is hot. The water must be cold before you clean the drain pump.
Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. • Unscrew the hose from the machine. Keep a rag nearby because some water may flow. • Clean the filter in the valve with a stiff brush or with the piece of cloth. Close the pump door. Caution! When the appliance is in use and depending on the programme selected there can be hot water in the pump.
Emergency emptying out If the appliance cannot drain the water, proceed as follows to empty out the machine: 1. pull out the plug from the power socket; 2. close the water tap; 3. if necessary, wait until the water has cooled down; 4. open the pump door; 5. place a container on the floor below the recess of the drain pump; 6. press the two levers and pull forward the drainage duct to let the water flow out; 7.
Problem Possible cause/Solution The machine does not fill: The water tap is closed. • Open the water tap. The inlet hose is squashed or kinked. • Check the inlet hose connection. The filter in the inlet hose or in the inlet valve filter are blocked. • Clean the water inlet filters (see ‘Cleaning the water inlet filters’ for more details). The door is not properly closed. • Close the door firmly. The machine fills then empties immediately: The end of the drain hose is too low.
Problem Possible cause/Solution The door will not open: The programme is still running. • Wait the end of washing cycle. The door lock has not been released. • Wait until the door is released. There is water in the drum. • Select drain or spin programme to empty out the water. The machine vibrates is noisy: The transit bolts and packing have not been removed. • Check the correct installation of the appliance. The support feet have not been adjusted • Check the correct levelling of the appliance.
Problem Possible cause/Solution The machine does not dry or does not dry properly: The drying time or the dryness degree has not been selected. • Select the drying time or the dryness degree. The water tap is not turned on. • Open the water tap. The drain filter is clogged. • Clean the drain filter. The machine is overloaded. • Reduce the laundry load in the drum. The selected drying programme, time or dryness degree was not suitable for the laundry.
Consumption values Programme Energy consumption (KWh) Water consumption (litres) 2.6 69 Cottons 60° 1.6 65 Cotton Energy Saving Programme 60° 1) 1.05 57 Cottons 40° 0.95 65 Synthetics 40° 0.60 55 Delicates 40° 0.70 69 Wool/ Handwash 30° 0.35 58 White Cottons 90° Programme duration (Minutes) For the duration of the programmes, please refer to the display on the control panel.
Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable. Any necessary adjustment can be made with a spanner.
Water drainage This appliance is designed to be permanently plumbed into your home's drainage system using one of the following methods. 1. Into a drainage standpipe. If your drain hose looks like this (see beside) you do not require the “U” piece”. Just push the hose firmly in to the standpipe. Firstly form a hook in the end of the drain hose using the “U” piece” supplied. 2. Onto a sink outlet spigot.
SHOWER SINK TOILET BATH BIDET WASHING MACHINE DISHWASHER RAINWATER ‘RUN-OFF’ FOUL DRAIN SURFACE WATER DRAINS & SEWERS UNTREATED DISCHARGE RIVER FOUL SEWERS SEWAGE TREATMENT WORKS TREATED DISCHARGE RIVER Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Warning! THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed.
132935112-A-492011 www.zanussi.