User Manual GETTING STARTED? EASY.
SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
• • • • • • WARNING: Do not damage the refrigerant circuit. WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer. Do not use water spray and steam to clean the appliance. Clean the appliance with a moist soft cloth. Only use neutral detergents. Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
CARE AND CLEANING USE WARNING! Risk of injury or damage to the appliance. WARNING! Risk of injury, burns, electric shock or fire. • • • • • • • • • • • • Do not change the specification of this appliance. Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer. Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility.
Climate class Ambient temperature SN +10°C to + 32°C N +16°C to + 32°C ST +16°C to + 38°C T +16°C to + 43°C Some functional problems might occur for some types of models when operating outside of that range. The correct operation can only be guaranteed within the specified temperature range. If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre.
OPERATION CONTROL PANEL 1 8 7 6 5 4 3 2 1 Display 2 Freezer Temperature warmer button 7 Fridge Temperature colder button 8 ON/OFF 3 Freezer Temperature colder button 4 OK 5 Mode It is possible to change predefined sound of buttons by pressing together Mode and temperature colder button for a few seconds. Change is reversible. 6 Fridge Temperature warmer button DISPLAY A B C D E F G Off min L K J I H SWITCHING ON 1. Connect the mains plug to the power socket. 2.
The set temperature will be reached within 24 hours. After a power failure the set temperature remains stored. SWITCHING ON THE FRIDGE To switch on the fridge it is enough to press the fridge temperature regulator. To switch on the fridge in the other way: 1. Press Mode until the corresponding icon appears. The Fridge OFF indicator flashes. 2. Press OK to confirm. The fridge OFF indicator goes off. To select a different set temperature refer to "Temperature regulation". SWITCHING OFF THE FRIDGE 1.
TheDrinksChill indicator is shown. The Timer start to flash (min). At the end of the countdown the DrinksChill indicator flashes and an audible alarm sounds. Press OK to switch off the sound and terminate the function. To switch off the function repeat the procedure until the DrinksChill goes off. It is possible to change the time at any time during the countdown and at the end by pressing the Temperature colder button and the Temperature warmer button.
When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours with the QuickFreeze function turned on. Place the fresh food to be frozen in the top compartment. The maximum amount of food that can be frozen in 24 hours is specified on the rating plate, a label located on the inside of the appliance. The freezing process lasts 24 hours, during this period do not add other food to be frozen.
• • A sudden cracking noise from inside appliance caused by thermic dilatation (a natural and not dangerous physical phenomenon). A faint click noise from the temperature regulator when the compressor switches on or off. HINTS FOR ENERGY SAVING • Do not open the door frequently or leave it open longer than absolutely necessary. • Do not remove the cold accumulators from the freezer basket. HINTS FOR FRESH FOOD REFRIGERATION • Do not store warm food or evaporating liquids in the refrigerator.
2. Regularly check the door seals and wipe them clean to ensure they are clean and free from debris. 3. Rinse and dry thoroughly. 4. If accessible, clean the condenser and the compressor at the back of the appliance with a brush. This will improve the performance of the appliance and save electricity consumption. DEFROSTING OF THE REFRIGERATOR Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use.
Problem Solution There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The cabinet has been recently switched on or the temperature is too high. Refer to "High temperature alarm". The temperature in the appliance is too high. Contact a qualified electrician or contact the nearest Authorised Service Centre. The door is left open. Close the door.
Problem Possible cause Solution Water flows on the floor. The melting water outlet is not connected to the evaporative tray above the compressor. Attach the melting water outlet to the evaporative tray. Temperature cannot be set. The "QuickFreeze function" or "QuickChill function" is switched on. Switch off "QuickFreeze function" or "QuickChill function" manually, or wait until the function resets automatically to set the temperature. Refer to "QuickFreeze function" or "QuickChill function".
TECHNICAL DATA Dimensions of the recess Height mm 1780 Width mm 560 Depth mm 550 Rising time Hours 21 Voltage Volts 230 - 240 Frequency Hz 50 The technical information is situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENTAL CONCERNS with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. Recycle materials with the symbol .
0016 222375772-A-282018 WWW.ZANUSSI.
