User manual

Problem Possible cause Solution
The compressor operates con-
tinually.
The temperature is not set correctly. Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too fre-
quently.
Do not keep the door open longer than
necessary.
The product temperature is too high. Let the product temperature decrease to
room temperature before storage.
The room temperature is too high. Decrease the room temperature.
Water flows on the rear plate of
the refrigerator.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
This is correct.
Water flows into the refrigerator. The water outlet is clogged. Clean the water outlet.
Products prevent that water flows into
the water collector.
Make sure that products do not touch
the rear plate.
Water flows on the ground. The melting water outlet does not flow
in the evaporative tray above the com-
pressor.
Attach the melting water outlet to the
evaporative tray.
The temperature in the appliance
is too low.
The temperature regulator is not set
correctly.
Set a higher temperature.
The temperature in the appliance
is too high.
The temperature regulator is not set
correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too high. Let the product temperature decrease to
room temperature before storage.
Many products are stored at the same
time.
Store less products at the same time.
There is no cold air circulation in the
appliance.
Make sure that there is cold air circula-
tion in the appliance.
Replacing the lamp
1. Disconnect the mains plug from the mains socket.
2. Press on the rear
hook and at the
same time slide the
lamp cover in the
direction of the ar-
row.
3. Replace the lamp
with one of the
same power and
specifically designed for household appliances. (the
maximum power is shown on the light lamp cover)
4. Install the lamp cover by sliding it into its original
position.
5. Connect the mains plug to the mains socket.
6. Open the door. Make sure that the lamp comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Con-
tact the Service Center.
8