User manual

ManualsBrandsZanussi ManualsDomestic AppliancesPI44GW

2 3

Hobs

Technical characteristics Pag. 3

General warnings Pag. 4

Instructions for user Pag. 5

Use Pag. 6

Maintenance and cleaning Pag. 7

Instructions for installer Pag. 7

Gas connection Pag. 8

Electrical connection Pag. 9

Adaption of hob burners to different types of gas Pag. 10

Insertion in kitchen units Pag. 12

Technical assistance and spareparts Pag. 15

CONTENTS

MANUFACTURER: ELECTROLUX ZANUSSI S.p.A.

Viale Bologna, 298

47100 FORLÌ (Italy)

OPERATING AND INSTALLATION MANUAL

TECHNICAL DATA

Power of gas burners

Rapid burner (large) 10,00 MJ/h

Semi-rapid burner (medium) 6,12 MJ/h

Auxiliary burner (small) 3,60 MJ/h

Appliance operation Natural Gas

L.P.G. Gas

Appliance caliber Natural Gas 1,0 kPa 25,84 MJ/h

Conversion to use with L.P.G. 2,75 kPa 25,56 MJ/h

Gas entry connection G1/2

Voltage tension 240 V 50 Hz

ZANUSSI

Summary of content (7 pages)

PAGE 1
ZANUSSI Hobs OPERATING AND INSTALLATION MANUAL 2 CONTENTS Technical characteristics General warnings Instructions for user Use Maintenance and cleaning Instructions for installer Gas connection Electrical connection Adaption of hob burners to different types of gas Insertion in kitchen units Technical assistance and spareparts TECHNICAL DATA 10,00 MJ/h Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag. Pag.
PAGE 2
This appliance has been designed for use by adults. Take care, therefore, that children do not attempt to play with it. This appliance has been designed for cooking purposes only. It must not be used for any other purposes, or be destined to professional or industrial use. Where this appliance is installed in marine craft or in caravans, it shall not be used as a space heater. The work of installation must be carried out by competent and qualified installers according to the regulations in force.
PAGE 3
INSTRUCTIONS FOR USER INSTALLATION Auxiliary (small) Semi-rapid (medium) Rapid (large) Burner 80 mm 120 mm 160 mm Min. diam. 160 mm 220 mm 240 mm Max. diam. Minimum and maximum diametres of recipients which can be placed on the burners. IMPORTANT If after a few attempts the burner does not ignite, check that the baffle and its cap are correctly positioned. To interrupt the supply of gas, turn the switch in a clockwise direction to the position « ».
PAGE 4
CONNECTION TO THE GAS SUPPLY Carry out the connection to the gas plant only by means of a rigid metallic pipe conforming to the regulations in force. The joint for the entry of gas into the appliance is threaded GJ 1/2". Carry out the connection avoiding any type of stress on the appliance. The adjustable joint permits the location of the supply tube in the appropriate site situated on the side of the protection box of the hob itself (Fig. 2).
PAGE 5
Auxiliary Semi-rapid Rapid Burner TAP FO 0254 28 35 45 Ø By-pass of tap 1/100 mm Fig. 7 Fig. 6 Fig. 5 ADAPTATION TO DIFFERENT TYPES OF GAS SUBSTITUTION OF THE NOZZLES Remove the grills: Remove the caps and baffles from the burners: With a tubular spanner no. 7 unscrew and remove (fig. 5) the nozzles substituting them with those corresponding to the type of gas used (see tab): Remount the parts carrying out the operations described in reverse.
PAGE 6
0 51 72 mm. 480 mm. 560 mm. 9 Kg. 0 58 5 60 INSTALLATION IN THE KITCHEN UNITS 74 CUT OUT DIMENSIONS 13 0 48 DIMENSIONS 554 SR A 16,5 477 16,5 12 Height: Depth: Width: Weight: SR R 580 FO 0697 INSERTION AND ASSEMBLY a b) Possible space useful for connections a) Panel of dismantled unit Fig. 12 a) Seal The hobs can be installed in a unit having an opening for installation of the dimensions illustrated in fig. 11.
PAGE 7
Kitchen unit with oven 120 cm 2 180 cm 2 Fig. 16 FO 0479 FO 0938 50 cm 2 360 cm 2 Fig. 19 Fig. 17 The opening should have the dimensions shown in figs. 13-14 and be provided with supports to permit an efficient ventilation. To avoid excessive overheating it is advisable to carry out installation as (figs. 16-17). The electrical connection of the hob and that of the oven must be carried out separately, both for electrical reasons and to facilitate the frontal extraction of the oven. FO 0939 .