EN User Manual Cooker ZCG61211WA ZCG61211XA FR PT ES AE
Contents Safety information Safety instructions Product description Before first use Hob - Daily use Hob - Hints and tips Hob - Care and cleaning Oven - Daily use 2 3 6 7 7 8 9 9 Oven - Clock functions Oven - Using the accessories Oven - Hints and tips Oven - Care and cleaning Troubleshooting Installation Energy efficiency 11 12 13 16 18 19 24 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
• • • • • • • • • • • Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. Never try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket. Do not store items on the cooking surfaces. Do not use a steam cleaner to clean the appliance. Metallic objects such as knives, forks, spoons and lids should not be placed on the hob surface since they can get hot. Remove any spillage from the lid before opening.
Electrical Connection appliance according to current installation regulations. Pay attention to requirements regarding adequate ventilation. WARNING! Risk of fire and electrical shock. • • • • • • • • • • • • • All electrical connections should be made by a qualified electrician. The appliance must be earthed. Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact an electrician. Always use a correctly installed shockproof socket.
• • • • • • • • • • • • • • – do not keep moist dishes and food in the appliance after you finish the cooking. – be careful when you remove or install the accessories. Discoloration of the enamel has no effect on the performance of the appliance. It is not a defect in the sense of the warranty law. Use a deep pan for moist cakes. Fruit juices cause stains that can be permanent. Do not keep hot cookware on the control panel. Do not let cookware boil dry.
Disposal • • WARNING! Risk of injury or suffocation. • • • Contact your municipal authority for information on how to discard the appliance correctly. Disconnect the appliance from the mains supply. Cut off the mains cable and discard it. Remove the door catch to prevent children and pets to get closed in the appliance. Flat the external gas pipes. Service • • To repair the appliance contact an Authorised Service Centre. Use original spare parts only.
• • • Turnspit For roasting larger joints of meat and poultry. Grill deflector To protect the knobs when you use the grill. Storage compartment The storage compartment is below the oven cavity. To use the compartment, lift the lower front door then pull it down. WARNING! The storage compartment can become hot when the appliance operates. Before first use WARNING! Refer to Safety chapters. Initial Cleaning Remove all accessories from the appliance. Refer to "Care and cleaning" chapter.
In the absence of electricity you can ignite the burner without an electrical device. In this case approach the burner with a flame, push the relevant knob down and turn it to maximum position. Keep the knob pushed for equal or less than 10 seconds to let the thermocouple warm up. If the burner accidentally goes out, turn the knob to the off position and try to light the burner again after minimum 1 minute. A. B. C. D.
CAUTION! Make sure that the pots are placed centrally on the burner in order to get maximum stability and to get lower gas consumption. Diameters of cookware WARNING! Burner Diameter of cookware (mm) Rapid 160 - 260 Semi - rapid 140 - 240 Auxiliary 120 - 180 Use cookware with diameters applicable to the size of burners. Hob - Care and cleaning WARNING! Refer to Safety chapters. General information • • • • • Clean the hob after each use. Always use cookware with clean bottom.
Oven Functions Oven function 1 - 81) Application Off position The appliance is off. Pizza setting To make pizza. Heat settings Range of temperature levels adjustment for the oven . Grilling To grill flat food in the middle of the grill. To make toast. Oven lamp To illuminate the oven interior. To use this function, press the button for the lamp and turnspit. Turnspit To spit roasting meat. To use this function, press the button for oven lamp and turnspit.
After igniting the oven gas burner 1. Release the knob for the oven functions. 2. Close the oven door. 3. Turn the knob for the oven functions to set the necessary heat setting. Control the flame trough the holes in the bottom of the oven. Turning off the oven burner To put out the flame, turn the knob to the off position . Using the grill The grill temperature cannot be adjusted. To get a lower temperature or slower cooking time, lower the grill pan away from the flame.
Oven - Using the accessories WARNING! WARNING! Use oven gloves when you remove the turnspit. The turnspit and the grill are hot. There is a risk of burns. Refer to Safety chapters. Inserting the accessories Wire shelf: The turnspit does not stop if you open the oven door. The wire shelf has a special shape in the rear which help with the heat circulation. CAUTION! The maximum weight permitted on the turnspit is 4 - 5 kg. A B C D Put the shelf on the correct shelf position.
5. Use the screws to tighten the forks. 6. Put the tip of the spit into the turnspit hole. Refer to "Product description" chapter. 7. Put the front part of the spit on the support hook. 8. Remove the turnspit handle. 9. Light the grill. Refer to "Oven - Daily use" chapter. 10. Press the button for oven lamp and turnspit. 11. Make sure that turnspit rotates. 12. Close the oven door. When meat is ready press the turnspit button. Turn off the grill. Install the turnspit handle.
• Leave the meat for approximately 15 minutes before carving so that the juice does not seep out. To prevent too much smoke in the oven during roasting, add some water into the deep pan. To prevent the smoke condensation, add water each time after it dries up. • Cooking times Cooking times depend on the type of food, its consistency, and volume. Initially, monitor the performance when you cook. Find the best settings (heat setting, cooking time, etc.
Food Quantity (g) Thermostat position Time (min) Shelf position Accessories Cheese cake 2600 3 80 - 90 3 aluminium baking tray Cheese cake 2600 3 70 - 80 3 baking tray Swiss apple flan5) 1900 6-7 50 - 60 3 aluminium baking tray Swiss apple flan 1900 6-7 40 - 50 3 baking tray Christmas cake 6) 2400 3-4 60 7) 3 aluminium baking tray Christmas cake 6) 2400 3-4 60 3) 3 baking tray Quiche Lorraine5) 1000 5-6 50 - 60 3 1 round tray (diameter: 26 cm) Peasant bread 6)
Food Buttered cake5) Quantity (g) 600 Thermostat position 3 Time (min) 20 - 25 Shelf position 3 Accessories baking tray 1) Preheat the oven for 10 minutes. 2) After you switch off the appliance, leave the cake in the oven for 7 minutes. 3) After you switch off the appliance, leave the cake in the oven for 5 minutes. 4) Preheat the oven for 20 minutes. 5) Preheat the oven for 15 minutes. 6) Preheat the oven for 15 minutes with the thermostat set at position 8.
Clean the glass panel with water and soap. Dry the glass panel carefully. When the cleaning is completed, install the glass panel and the oven door. Do the above steps in the opposite sequence. 1 Open the door fully and hold the two door hinges. 2 Lift and turn the levers on the two hinges. 3 Close the oven door 4 Put the door on a soft halfway to the first cloth on a stable opening position. surface. Then pull forward and remove the door from its seat.
Troubleshooting WARNING! Refer to Safety chapters. What to do if... Problem Possible cause Remedy There is no spark when you try to activate the spark generator. The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply. Refer to the connection diagram. There is no spark when you try to activate the spark generator. The fuse is released. Make sure that the fuse is the cause of the malfunction.
Service data If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. The necessary data for the service centre is on the rating plate. The rating plate is on the front frame of the appliance cavity. Do not remove the rating plate from the appliance cavity. We recommend that you write the data here: Model (MOD.) ......................................... Product number (PNC) ......................................... Serial number (S.N.) ..............
Gas replacement: G20 (2H) 20 mbar Bypass diameters BURNER Ø BYPASS1) 1/100 mm Auxiliary 29 / 30 Semi-rapid 32 Rapid 42 Oven 44 1) Type of bypass depends on model. Gas burners for NATURAL GAS G20 20 mbar BURNER NORMAL POWER kW REDUCED POWER kW INJECTOR MARK 1/100 mm 3.0 0.72 / 0.751) 119 2.0 / 1.91) 0.43 / 0.451) 96 Auxiliary 1.0 0.35 70 Oven 2.7 0.90 120 Grill 1.9 - 108 Rapid Semi-rapid 1) Type of bypass depends on model.
Gas burners for LPG G31 37 mbar BURNER NORMAL POWER kW REDUCED POWER kW INJECTOR MARK 1/100 mm NOMINAL GAS FLOW g/h Rapid 3.0 0.72 88 214.24 Semi-rapid 2.0 0.43 71 142.83 Auxiliary 1.0 0.35 50 71.41 Oven 2.7 0.9 80 192.82 Grill 1.65 - 71 117.83 Gas connection Use a fixed connections or use a flexible stainless steel pipes in compliance with the regulation in force.
WARNING! Before you replace the injectors, make sure that the gas knobs are in the Off position. Disconnect the appliance from the electrical supply. Let the appliance cool down. There is a risk of injury. The appliance is set to default gas. To change the setting always use the gasket sealing. A B C E If the supply gas pressure is not constant or it is different from the necessary pressure, install an applicable pressure adjuster on the gas supply pipe.
The model determines the position of the bypass screw A. BA A 2. Release the screw C, which keep the burner in position. Changing from natural gas to liquid gas 1. Fully tighten the bypass screw. 2. Put the knob back. 3. Connect the appliance to the electricity. C Changing from liquid gas to natural gas 3. Carefully move the burner off the injector support D. D E F 4. Slowly move it to the left side. Make sure that the burner bush stays on the burner mouthpiece.
Test the grill injectors. A Electrical installation WARNING! The manufacturer is not responsible if you do not follow the safety precautions from Safety chapters. 2. Release the burner injector with a 7 mm socket spanner and replace it with a right one. This appliance is supplied with a main plug and a main cable. WARNING! The power cable must not touch the part of the appliance shown in the illustration. 3. Assemble the burner in a reverse sequence.
Product Fiche and information for ovens according to EU 65-66/2014 Supplier's name Zanussi Model identification ZCG61211WA ZCG61211XA Energy Efficiency Index 104.3 Energy efficiency class A Energy consumption with a standard load, conventional mode 1.67 kWh/cycle 6.02 MJ/cycle Number of cavities 1 Heat source Gas Volume 51 l Type of oven Oven inside Freestanding Cooker Mass EN 15181 Measuring method of the energy consumption of gas fired ovens.
www.zanussi.
www.zanussi.
867313188-D-072017 www.zanussi.
