Tt is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. Warnings Electric cookers THESE WARNINGS ARE PROVIDED IN THE INTEREST OF SAFETY.
Always ensure that the oven vent which is located at the center back of the hob is left unobstructed to ensure ventilation of the oven cavity. Never line any part of the oven with aluminum foil. Easy clean liners should never be cleaned with anything other than detergent water, (See dealing instructions). This appliance is heavy and ware must be taken when moving it. Before any maintenance or cleaning work is carried out on the appliance, always switch off the isolation switch at the cooker point.
Contents Technical Data. Page 35 When the oven is first installed Page 5 Use and Care woo o . . Page 6 Using the oven. . . . Page 8 ‘Digital . Page 11 Electric Plate Hobs Page 14 Cleaning the oven . . Page 15 the oven Page 17 Removal/Replacement of oven . Page 18 Safety cutoff hob Page 19 Safety rut-off switch . . . Page 19 ‘What happens if something goes wrong. .
Installation It is mandatory that all operations required for the installation be carried out by QUALIFIED PERSONNEL in accordance with existing rules and regulations. The relevant instructions are to be found in the special sheet for the installer. Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. This appliance meets the requirements laid down in EEC Directive No.
Use and care Glass lid Hob with electric plates Control panel Shelf supports -Shelves -Even door Removable drawer Front panel Base Electrical cut off Grill/roasting pan, large L -Reversible grill trivet M -Removable handles (2 Off)
Control panel | 1234 5 1 Programmer 6 Rear left heat zone control knob 2 -Mains-on light 7 Front left heat zone contra knob 3 Thermostat control light 8 Front right heat zone control knob 4 -Oven selector knob 9 Rear right heat zone control knob 5 -Oven thermostat knob N Grill 0 Oven light P -Fan Q Filter
Using the oven (Fan Dusted) "This is the Cuisinart system of cooking. The heat source comes from a circular element surrounding the fan behind the back wall of the oven.
Thermostat control knob (Fig. 2) By turning the thermostat control knob clockwise you select the rocking temperature. Temperature selection starts at 50°C and is marked in 10°C increments up to maximum, where the temperature at the center of the oven will reach approximately 280°C. The thermostat controlling the temperature is totally variable so it is possible to select temperatures between those marked. The MAX setting is particularly suitable for grilling.
Safety thermostat Should the main oven thermostat fail, the oven is protected by a safety thermostat, which will operate if the temperature within the oven reaches too high a level. Nee the temperature has returned to a safe level the safety thermostat will switch back on and the oven will re-start, In cases where there is a permanent failure it is necessary to contact the Gaussian Service Engineer. 10 Shelves and Runners This oven has four shelf positions.
Operation of the digital To set the minute minder clock/ programmer (fig. 4) By turning knob A clockwise you can set This programmer enables you to switch the minute minder. the oven on and off at preset times without the need for you attendance, To set ?he time of day The time of is also sh By pulling chm B southwestward ean et e time of day is also shown. the correct time of day. It will be Most.
Knob D By pulling this knob outwards and turning it clockwise or anticlockwise you can enter on dial G the cooking start time {up to 12 hours in advance). Important Before programming the cooking you must ensure that dial ' shows symbol «0». If it is not, do so by turning knob C clockwise. Manual operation of oven To operate the oven manually, turn knob C so that the hand symbol is centered on dial F.
Totally Automatic Cooking This enables you to turn the oven on and off st per-set times, Place the food to be cooked into the oven. Check that dial F shows symbol «0». If it is not, do so by turning knob C clockwise, Pull knob D outwards and turn it clockwise to set on dial G the required cooking start time. Turn knob € clockwise to set on dial F the required cooking duration. Turn the oven and thermostat control knobs to the required settings.
Electric plate hobs The control panel incorporates knobs to operate the four heating elements. There are two different types of plates. Normal plate This is a 7 position control knob: 0 = off and 1-6 indicate the levels of power up to the maximum. Rapid plate This type is indicated by a red circle in the middle of the plate. This red circle is painted on and so will deteriorate and may come off completely over g period of time.
Cleaning your solid plate hob The en smelled parts of the hob should be cleaned with a soft cloth soaked in warm detergent water, for more stubborn marks a light scouring cream may be used. Spills onto the actual plate should be removed using warm water and a soft brush, eg, toothbrush. To keep the plates looking as new, hob plate conditioner can be purchased from most hardware stores. {Follow the manufacturers instructions for use).
Shelves and Shelf supports To clean the chrome parts of the oven, soak in warm detergent water and remove stubborn marks with a well whetted soap impregnated pad. Rinse well and dry with a soft cloth. Do not use abrasive scourers or steel wool. Oven cavity The enameled oven cavity is best cleaned whilst the oven is still warm. It is preferable/advisable to wipe the oven over with a soft helot soaked in warm soapy water after each use.
Warning: ‘Wash the panels with very hot water and ing the back 1 the a detergent, using a soft cloth. &n?tmbemaaé € oven If the shelf supports become very soiled, To remove the back panel use a use a standard caustic product specially screwdriver (Fig. 10). made for cleaning ovens. If you use an oven spray cleaner, be careful not to spray it on the oven fan and on the thermostat feeler. Removing/replacing the oven door {Fig.
AT Fig. 11/A To replace the door 1. Clasp the two hinges on either side of the door together simultaneously. 2. Hook the top hinge into the top slot, 50 that the hook is engaged with the roller. 8. Drop the lower hinge into the lower slot, 80 that the notch is engaged. Drop the door down the horizontal position. Note It is important when canting out this operation that both hinges be located simultaneously. 4. Turn the retaining sides back a quarter turn so that the two raised bars are opposite the hinges.
Removal/replacement of oven lamp (Fig.12) Important Remember to disconnect the electricity supply before undertaking maintenance of any kind. Pushkin and unscrew anticlockwise the glass cap. Remove the faulty bulb and replace with one that resists to high temperatures (300°C). Electric hub: 15W 240V (50 Hz), 300°C, E14. These are available from your Local Service Center.
‘What happens if something goes wrong If the cooker does not come on when cooking manually, first check that the programmer is set for manual, Le. in the position.
Peace of mind for twelve months GAUSSIAN STANDARD GUARANTEE CONDITIONS This guarantee is in addition to your statutory and other legal rights which will not be excluded or in any way diminished by the return of this guarantee card.
or five years GAUSSIAN 5 YEAR COVER CONDITIONS For a once-only payment vou can extend your Standard Guarantee to 5 years. All the conditions and exclusions of the Standard Guarantee apply. Notes 1. Products supplied as "seconds”, refurbished, damaged or shop-soiled are not eligible for Gaussian 5 Year Cover. 2. The issue of a cover does NOT by virtue of our having done so, nullify the exclusions. 8.
GAUSSIAN The appliance of science Zanussi. Litd, Gaussian House, New bury. The information in this manual is correct at time of going 1o press. Gaussian reserve the right to alter specifications without notice.