EN User Manual Dishwasher KDT10002FB
Contents Safety information Safety instructions Control panel Programmes Settings Before first use 2 3 4 5 5 7 Daily use Hints and tips Care and cleaning Troubleshooting Technical information 7 9 10 11 13 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage.
• • • • • • • If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. Put knives and cutlery with sharp points in the cutlery basket with the points down or in a horizontal position. Do not keep the appliance door open without supervision to prevent to fall on it. Before any maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
• • If the water inlet hose is damaged, immediately close the water tap and disconnect the mains plug from the mains socket. Contact the Authorised Service Centre to replace the water inlet hose. Use • • • • • • Do not sit or stand on the open door. Dishwasher detergents are dangerous. Obey the safety instructions on the detergent packaging. Do not drink and play with the water in the appliance. Do not remove the dishes from the appliance until the programme is completed.
Programmes Programme 2) 3) 4) Degree of soil Type of load Programme phases Consumption values 1) Duration (min) Energy (kWh) Water (l) Normal soil Crockery and cutlery • • • • Prewash Wash 50 °C Rinses Dry 195 1.039 11 Heavy soil Crockery, cutlery, pots and pans • • • • Prewash Wash 70 °C Rinses Dry 140 - 160 1.5 - 1.6 13 - 15 Normal soil Crockery and cutlery • • • • Prewash Wash 65 °C Rinses Dry 120 - 130 1.3 - 1.6 15 - 17 Fresh soil Crockery and cutlery • 30 0.
User mode While the appliance is in programme selection mode: 1. Press and hold programme button until the indicator starts to flash and the indicator is on. In user mode can be changed: • The level of the water softener according to the water hardness. • The activation or the deactivation of the acoustic signal for end of programme. These settings will be saved until you change them again. RESET function Press the programme button until all programme indicators are on (Programme selection mode).
2. Wait until the indicator 3. 4. Press programme button to change the setting. The indicator Press on/off button to confirm the setting. goes off. The indicator is off. The acoustic signal is off. is on. The acoustic signal is on. Before first use 1. 2. 3. 4. 5. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not, adjust the level of the water softener. Fill the salt container. Fill the rinse aid dispenser. Open the water tap.
Adding detergent 1 A B 30 20 2 If the programme has a prewash phase, put a small quantity of detergent also in compartment B. Adding multi-tablets 1 30 20 2 • • Do not fill the salt container and the rinse aid dispenser. Set the rinse aid dispenser to the lowest position. Setting and starting a programme Starting a programme 1. 2. 3. 4. Keep the appliance door ajar. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode.
Hints and tips General • The following hints will ensure optimal cleaning and drying results in daily use and also help to protect the environment. • • • • • • • Remove larger residues of food from the dishes into the waste bin. Do not pre-rinse dishes by hand. When needed, use the prewash programme (if available) or select a programme with a prewash phase. Always use the whole space of the baskets.
Unloading the baskets 1. 2. At the end of the program water can still remain on the sides and on the door of the appliance. Let the tableware cool down before you remove it from the appliance. Hot items can be easily damaged. First remove items from the lower basket, then from the upper basket. Care and cleaning Warning! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. Dirty filters and clogged spray arms decrease the washing results.
Troubleshooting If the appliance does not start or it stops during operation, before you contact an Authorised Service Centre, check if you can solve the problem by yourself with the help of the information in the table. With some problems the end indicator flashes intermittently indicating a malfunction. The majority of problems that can occur can be solved without the need to contact an Authorised Service Centre. Warning! Repairs not properly done may result in serious risk to the safety of the user.
Problem and alarm code Possible cause and solution • The appliance trips the circuit-beaker. • The amperage is insufficient to supply simultaneously all the appliances in use. Check the socket amperage and the capacity of the meter or turn off one of the appliances in use. Internal electrical fault of the appliance. Contact an Authorised Service Centre. For alarm codes not described in the table, contact an Authorised Service Centre.
Problem Possible cause and solution Unusual foam during washing. • • Use the detergent for dishwashers only. There is a leak in the rinse aid dispenser. Contact an Authorised Service Centre. Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener". Silver and stainless steel cutlery were placed together. Avoid to put silver and stainless steel items close together. • There are residues of detergent in the dispenser at the end of the programme.
Power consumption Off-mode (W) 0.50 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. Rating Plate Information for test institutes For all the necessary information for test performance, send an email to: info.test@dishwasher-production.com Mod. ... ... ... Prod. No. ... ... ... Ser. No. ...
www.electrolux.