Instructions / Assembly

Page 7 of 11
8. Allow at least 6’’- 12’’ of liner to extend above the top of the chimney, for attaching the Top Support
and Rain Cap. Next, place the Chimney Flashing over the liner and secure it to chimney top using
suitable anchors. Using a quality high temperature sealant, caulk all joints and paint as necessary.
9. Slide Top Support over liner down to the top of the flashing collar allowing about a 1’’ overlap on the
flashing collar. Trim the liner level to top of Support using a knife or hacksaw. Next, insert Rain Cap
into the liner. Tighten up on gear clamp supplied on Top Support crimping liner onto the Rain Cap
base allowing it to overlap the flashing collar preventing any rain from getting between flashing collar
and liner.