User's Manual

Troubleshooting
Symptom Cause Measure to be taken
The machine does not
operate.
The power cord is
disconnected.
Insert the power cord plug all
the way.
The breaker is [OFF]. Turn [ON] the breaker.
The heater roller is being
heated rapidly.
Wait until the rapid heating is
completed.
The edge of the paper is
displaced.
A laminate is attached to the
heater roller.
Remove the laminate.
The packing paper is not
attached properly.
Reattach the paper.
The error cannot be released
even after packing paper
has been re filled.
The packing paper is not
routed to the paper out
sensors.
Route the packing paper to
the paper out sensors.
The print is so light even
after the ink ribbon has been
replaced with a new one.
The printer head is dirty. Clean the printer head.
The barcode cannot be read.
The barcode reader lamp is
OFF.
Press the [Barcode Reader
Flash] switch.
その他
115