Digital Electronic Torque Wrench Quick Start Guide Model 60648
BEFORE USING THE WRENCH BATTERY INSTALLATION Remove the battery cover. Insert two AAA batteries matching the -/+ polarities of the battery to the battery compartment. Put on the battery cover and fasten it tightly according to the following figures. ATTENTION: When opening the battery cover of the wrench, you can see a viewing window for the water contact indicator. Through this viewing window, you can check if the wrench is damaged by water penetration where the water contact indicator turns red.
Unit Selection: kg-cm SETUP STEP 2: SET TORQUE VALUE Pre-setting Torque Value 4 1 Press 3 2 Increase Target Torque Value 1 Power On/Clear 2 Unit Selection/Setting 3 Pre-setting No. Decrease Target Torque Value 4 Up/Down Button Press POWER ON Press to power on the digital torque wrench.
MAINTENANCE AND STORAGE ATTENTION: To maintain accuracy, a one-year periodic recalibration is recommended. Please contact your local dealer for calibration details. CAUTION: 1. Over-torque (110% of Max. torque range) could cause breakage or loss pf accuracy. 2. Do not shake violently or drop wrench. 3. Do not use the wrench as a hammer. 4. Do not leave the wrench in any place exposed to excessive heat, humidity, or direct sunlight. 5. Do not use the torque wrench in water (not waterproof). 6.
