Installation Guide



DRAIN INSTALLATION

 





 





 















PAGE 1
WALL-MOUNT FAUCET DRAIN INSTALLATION 1. Dissasemble the drain assembly and lay the parts aside, in the same order they were removed. See the illustration below as a reference if needed. 2. Apply plumber’s tape to the threading on the tailpiece, then reattach the tail piece to the pop-up drain �ange. Pop-Up Drain Flat Rubber Gasket Tapered Rubber Gasket Plastic Friction Washer Lock Nut Tailpiece 3. Slide the �at rubber gasket up the tailpiece until it meets the lip of the pop-up drain �ange.
PAGE 2
WALL-MOUNT FAUCET 4. Insert the drain �ange and tailpiece through the top of your sink’s drain hole. 6. Thread the lock nut onto the drain �ange. Hand tighten until secure, then �nish tightening with a basin wrench once the drain is properly aligned. Important: Be careful not to overtighten, which could crack a porcelain sink or stone countertop. COUNTERTOP COUNTERTOP COUNTERTOP 5.