Installation Guide

ManualsBrandsYASINU ManualsBath48 in. W x 22 in. D Engineered stone composite Vanity Top in White with White Rectangular Single Sink

UNDERMOUNT SINK VANIT Y

For Warranty information, please visit: signaturehardware.com/services/warranty

GETTING STARTED

TOOLS AND MATERIALS:

BEFORE YOU BEGIN

We recommend consulting a professional if you are



plumbing. Signature Hardware accepts no liability for any



counter top, or personal injury during installation.

Observe all local plumbing and building codes.



damage is found, contact our Customer Relations

team at 1-(408) 728-6543.

*not included

Ensure that you have gathered all the required

materials that are needed for the installation.





Ensure that there is adequate support behind the

bathroom wall before installation.

PLANNING





be found and downloaded from the product page on

our website.





recommend performing any rough-in procedures with

the vanity on site.

Tape Measure*

Drill*

Screwdriver*

Stud Finder

Level

Neutral Cure

Silicone Sealant

Damp Cloth

Wood Shims

NEVER LIFT THE VANITY TOP FLAT NEVER CARRY THE VANITY TOP FLAT

From MAXWELL BATHROOM & KITCHEN INCM

(408) 728-6543

YASINU BATHROOM VANITY COUNTER TOP

Summary of content (6 pages)

PAGE 1
UNDERMOUNT SINK VANIT Y From MAXWELL BATHROOM & KITCHEN INCM BEFORE YOU BEGIN PLANNING We recommend consulting a professional if you are unfamiliar with installing bathroom �xtures and plumbing. Signature Hardware accepts no liability for any damage to the �oor, walls, plumbing, vanity cabinet, sink, counter top, or personal injury during installation. Use the vanity’s PDF speci�cation sheet as a reference when planning your layout.
PAGE 2
UNDERMOUNT SINK VANIT Y By MAXWELL BATHROOM & KITCHEN INCM CABINET INSTALLATION 1. Determine the location where you would like to install your vanity. 3. Place the vanity in the installation location. Verify that the vanity cabinet is level. If the vanity is not level, adjust the feet (if applicable) or use wooden shims to adjust as necessary. 2. Locate and mark the location of the studs to which you will fasten your vanity. You can locate studs by using a stud �nder. 4.
PAGE 3
UNDERMOUNT SINK VANIT Y By MAXWELL BATHROOM & KITCHEN INCM SINK INSTALLATION 1. Carefully turn the counter top over, resting it on a soft, stable surface to prevent damage. 3. Use a pencil or marker to draw an outline around the sink perimeter. Important: The counter top is very fragile. Take caution when handling, and have someone assist you. 4. Remove the sink from the counter top. Apply a bead of silicone sealant around the top edge of the sink rim. 2.
PAGE 4
UNDERMOUNT SINK VANIT Y By MAXWELL BATHROOM & KITCHEN INCM 5. Carefully place the sink upside down on the counter top, positioning it within your marked outline. Once positioned, press �rmly into place. 7. Repeat steps 1-6 to attach the second sink to your top. 6. At each of the bolt holes in the counter top, attach sink clips by placing the long end of the bracket �at against the sink lip. Screw the wing bolts through the brackets and bolt holes and tighten. 8.
PAGE 5
UNDERMOUNT SINK VANIT Y By MAXWELL BATHROOM & KITCHEN INCM COUNTER TOP INSTALLATION 1. Apply a bead of silicone sealant around the top edge of the vanity cabinet. 9. Wipe away any excess sealant with a damp cloth, and allow the sealant to dry. Once the sealant is dry, proceed to Step 3. 24 hr YASINU BATHROOM VANITY COUNTER TOP 2. With assistance from another person, slowly and carefully set the counter top onto the vanity cabinet. Once positioned, press �rmly into place.
PAGE 6
UNDERMOUNT SINK VANIT Y By MAXWELL BATHROOM & KITCHEN INCM 5. For stone tops, such as marble and granite, it is recommended that you apply a high-quality sealer to protect from staining and discoloration. Stone sealer should be reapplied once or twice per year, depending upon usage. 3. If you are installing a side-splash and/or back-splash, place a generous amount of silicone sealant on the back of it and press it into place against your bathroom wall. Fill any gaps that are left with silicone sealant.