Product Manual

Switching on and off

As shown in Fig.19-20

NOTE! Put the High-pressure washer on a smooth ground. Stand in a secure and

stable position.

WARNING! Before switching on, ensure you have completely assembled the

high-pressure washer and connected all connections.

To switch on

You should maintain the correct operating position every time, use the equipment by

placing one hand on the spray gun handle and the other on the lance.

1. Open the water inlet valve. (if using the potable water supply as resource) If using

the water container as resource, get started From step 2 directly.

NOTE! Before switching on, firstly purge pump around 5s by squeezing trigger gun .

Fig. 19

Fig. 20

2. To switch the pressure washer on, set the On/Off switch to ON.

3.Unlock the safety trigger lever on the spray gun, and press the trigger lever until

there is a steady stream of water.

To temporarily switch off

Release the trigger lever, at this point the equipment goes to standby. As soon as

you press the trigger lever again , the equipment restarts.

To completely switch off

As shown in Fig. 21

Y 4050PB indd 19 15-4-29 ��6 43